User manual SONY SLV-E230UY

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Mains lead must be changed only at qualified service shop. A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362, (i. [. . . ] Hold down P PAUSE and ON/STANDBY on the VCR simultaneously for more than three seconds. Each time you press > , the character changes as shown below. // until the character you want to correct flashes, then reset it. You can set up to 11 characters for your personal code. If the displayed personal code is wrong, press CLEAR and continue from step 2. To confirm you personal ID While the VCR is turned off and there is no tape in the VCR, hold down P PAUSE and ON/STANDBY on the VCR simultaneously for more than three seconds. the entered personal code appears on the TV screen. Press any button to enter normal viewing mode. Turn on your TV and set it to the video channel. The VCR turns on and starts playing automatically if you insert a tape with its safety tab removed. To Stop play Pause play Press p STOP P PAUSE PLAY FF during stop REW during stop To replay a recently watched scene You can immediately rewind and playback the scene you want to watch again. during playback , press REPLAY up to four times. The VCR rewinds the tape about 10 seconds on the counter for each press of the button, and restarts playback. To use the time counter At the point on the tape that you want to find later, press COUNTER RESET. The counter stops counting when it comes to a portion with no recording. While setting the menu on the TV screen, buttons for playback do not function. Turn on your TV and set it to the video channel. Make sure the tape is longer than the total recording time. Press the programme number buttons to enter the programme's PlusCode, then press SET. If you make a mistake, press VIDEO Plus+ before pressing SET and re-enter the correct number. The date, start and stop times, programme position and tape speed appear on the TV screen. If you want to change the date, tape speed, and the VPS/PDC function setting: To record the same programme every day or the same day every week, see "Daily/weekly recording" on page 30. [. . . ] Clean the video heads using the Sony T-25CLD, E-25CLDR, or T-25CLW video head cleaning cassette. If these cleaning cassettes are not available in your area, have the heads cleaned at your nearest Sony service facility (a standard service charge will be required). Do not use a commercially available liquid-type cleaning cassette other than Sony's, as it may damage the video heads. Consult your local Sony service facility for more information. [. . . ]