User manual SONY SLV-E530UX

[. . . ] Cancelling timer settings 48 Changing timer settings 48 Checking timer settings 48 Cleaning the video heads 56 Clock setting 14 Connecting the VCR and your TV 9 Colour system compatible colour systems 2 Counter 31 OPC (Optimum Picture Control) 51 Picture adjustment 51 Playback 30 at various speeds 44 frame-by-frame 44 slow motion 44 Presetting channels 20 Recording 33 saving 35 while watching another programme 35 Remote commander 5 RF channel 12 To prevent fire or shock hazard, do not expose the unit to rain or moisture. Mains lead must be changed only at qualified service shop. A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362, (i. [. . . ] To watch another TV programme while recording Press TV/VIDEO to turn off the VIDEO indicator in the display window. If the TV is connected to the VCR using only the aerial cable, skip this step. To save a recording To prevent accidental erasure, break off the safety tab as illustrated. To record on a tape again, cover the tab hole with adhesive tape. To select a programme position, you can use the programme number buttons on the remote commander. (ten's digit) button followed by the programme number buttons. You can select a video source from the LINE-1 (TV) or LINE-3 IN connector, or LINE-2 IN jacks using INPUT SELECT or PROG +/­. When you use PROG +/­, "L1, " "L3" or "L2" appears in the display window between the lowest programme position and the highest one. The display appears on the TV screen indicating information about the tape, but the information won't be recorded on the tape. If you don't want to watch TV while recording, you can turn off the TV. notes · The display does not appear during still (pause) mode or slow-motion playback. The display will not appear while playing an NTSC-recorded tape. If a tape has portions recorded in both PAL and NTSC systems, the time counter reading will not be correct. This discrepancy is due to the difference between the counting cycles of the two video systems. When you insert a non-standard commercially available tape, the remaining time may not be correct. If you play back the tape for about 30 seconds after you have inserted it, the remaining time will be displayed. The date, times, and programme position of that programme are set automatically. You can preset up to eight programmes at a time. Insert a tape with its safety tab in place. Make sure the tape is longer than the total recording time. Press the programme number buttons to enter the programme's PlusCode, then press SET. If you make a mistake, press VIDEO Plus+ before pressing SET and re-enter the correct number. [. . . ] Clean the video heads using the Sony T-25CLD, E-25CLDR, or T-25CLW video head cleaning cassette. If these cleaning cassettes are not available in your area, have the heads cleaned at your nearest Sony service facility (a standard service charge will be required). Do not use a commercially available liquid-type cleaning cassette other than Sony's, as it may damage the video heads. Consult your local Sony service facility for more information. [. . . ]