User manual SONY SLV-E730UX

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Mains lead must only be changed at a qualified service shop. A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. If the 13A fitted plug does not match the outlet socket in your home, please refer to your Appointed Sony Dealer for advice. [. . . ] To select a programme position, you can use the programme number buttons on the remote commander. (ten's digit) button followed by the programme number buttons. ⷠYou can select a video source from the LINE-1 (TV) or LINE-2 IN (Scart) connector using the INPUT SELECT button. ⷠThe display appears on the TV screen indicating information about the tape, but the information won't be recorded on the tape. ⷠIf you don't want to watch TV while recording, you can turn off the TV. notes · The display does not appear during still (pause) mode or slow-motion playback. ⷠThe display will not appear while playing an NTSC-recorded tape. ⷠIf a tape has portions recorded in both PAL and NTSC systems, the time counter reading will not be correct. This discrepancy is due to the difference between the counting cycles of the two video systems. ⷠWhen you insert a non-standard commercially available tape, the remaining time may not be correct. About 30 seconds after the tape begins playback, the tape remaining time will be displayed. The date, times, and programme position of that programme are set automatically. You can preset up to eight programmes at a time. Insert a tape with its safety tab in place. Make sure the tape is longer than the total recording time. ⷠTurn on your TV and set it to the video channel. Press the programme number buttons to enter the programme's PlusCode, then press SET. If you make a mistake before pressing SET, press VIDEO Plus+ and re-enter the correct number. If you want to change the date, tape speed, and the VPS/PDC function setting: 1 Push the joystick to ?To record the same programme every day or the same day every week, see "Daily/weekly recording" on page 37. To stop recording To stop the VCR while recording, push the joystick to p STOP. Daily/weekly recording In step 3 above, push the joystick to . [. . . ] ⷠWhen you play a tape with the same sound recorded on both the hi-fi and normal sound tracks, make sure AUDIO MIX in the OPTIONS menu is set to OFF. If you are using a monitor, set it to video input. ⷠIf the VCR is connected to the TV using only the aerial cable, make sure that RF MODULATOR in the OPTIONS menu is set to ON. To record on this tape, cover the tab hole. [. . . ]