User manual SONY SLV-ED313SG

[. . . ] The WAIT indicator goes off when all receivable channels are preset. If the TV screen changes to a different programme each time you press PROGRAM +/­, the channels are preset correctly. If the sound is distorted or noisy, the VCR is set to a TV system different from your area's system. Select the correct TV system and preset channels using the TUNER PRESET menu as shown on the next page. [. . . ] ⷠTo change the clock setting, push and hold the EASY TIMER knob on the VCR for more than three seconds. Push the EASY TIMER knob to finish setting the clock. To quit the Easy Timer setting mode without changing any settings, push the EASY TIMER knob repeatedly until the t indicator appears in the display window. To set the timer and clock setting using the remote commander You can also use the remote commander to set the Easy Timer and Easy Clock. the operations on the VCR and the remote commander correspond as follows: To Confirm the setting and go to the next setting Change the time by 15 minutes (in START/STOP mode) Change the time by one minute (in START/STOP mode) Select the programme Do this on the VCR Push the EASY TIMER knob Turn the EASY TIMER knob or hold PROGRAM +/­ down Press PROGRAM +/­ Do this on the remote commander Press EASY TIMER Hold PROG +/­ down You can also use the programme number buttons to set the clock, start and stop times, and the programme you want to record. Just press the programme number buttons to enter the hours and minutes. If you make a mistake, re-enter the correct digits before pressing EASY TIMER . To check or change the timer setting Push EASY TIMER knob repeatedly until the setting you want to check or change flashes. Then re-enter the new setting, if necessary. If you do not want to change any of the settings, push the EASY TIMER knob repeatedly until the t indicator appears in the display window. You can also change the timer setting using the TIMER SET/CHECK menu. for details , see page 40 in the English Operating Instructions. To cancel the timer setting To cancel the Easy Timer setting while entering a setting, press CLEAR on the remote commander or press PROGRAM + and ­ on the VCR at the same time. To use the VCR after setting the timer To use the VCR before a timer recording begins, just press ?You can also do the following tasks while the VCR is recording: · To watch the recorded programme right after recording with the Easy Timer The SEARCH MODE indicator starts flashing when the VCR finishes the Easy Timer recording. To watch the recorded programme, push the EASY TIMER knob. The VCR turns on, starts searching, then automatically starts playback from the beginning of the recording. To record from a source connected to the LINE-1 IN jacks, press INPUT SELECT or PROG +/­ or turn the EASY TIMER knob to display "L" in the display window. ⷠTo record NTSC signals, set the tape speed to SP or EP. To record in the EP mode, set the tape speed to "LP" in the display window. notes · You cannot set the Easy Timer if eight programmes have already been set. ⷠYou can set the timer for only one programme using the Easy Timer function. [. . . ] search for the point to start playback and set it to playback pause. Insert a tape with its safety tab in place into this (recording) VCR. To edit more precisely, press the X PAUSE buttons on the VCRs to release pause. ⷠTo cut out unwanted scenes while editing, press X PAUSE on this VCR when an unwanted scene begins. [. . . ]