User manual SONY SLV-EZ44AZ

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. The mains lead must only be changed at a qualified service shop. Caution Television programmes, films, video tapes and other materials may be copyrighted. unauthorized recording of such material may be contrary to the provisions of the copyright laws. [. . . ] To record on the tape again, cover the tab hole with adhesive tape. safety tab Tips · To select a programme position, you can use the programme number buttons on the remote commander. (ten's digit) button followed by the programme number buttons. ⷠYou can select a video source from the LINE-1 IN jacks using INPUT SELECT or PROG +/­ . ⷠThe display appears on the TV screen indicating information about the tape, but the information will not be recorded on the tape. ⷠIf you do not want to watch TV while recording, you can turn off the TV. notes · The display does not appear during still (pause) mode or slow-motion playback. ⷠIt may take up to one minute for the VCR to calculate and display the remaining tape length after you press DISPLAY. ⷠThe remaining tape length does not appear while playing in NTSC system. The Easy Timer function allows you to make a timer recording of a programme without turning on your TV. Set the recording timer to record only one programme that will be broadcast within the next 24 hours using the Easy Timer knob. If the VCR clock has not been set, you can also set the clock before setting the timer recording. Insert a tape with its safety tab in place. Make sure the tape is longer than the recording time. Set the recording stop time in the same way as in step 2, then press the EASY TIMER knob. Turn the EASY TIMER knob clockwise or counterclockwise to select the programme you want to record. When "­:­ ­" is displayed in the display window, the VCR clock has not been set. You need to set the clock using the Easy Clock function before setting the timer. You can also change the current time using the Easy Clock function. When "­:­ ­" is displayed in the display window, press the EASY TIMER knob. ⷠTo change the clock setting, press and hold the EASY TIMER knob on the VCR for more than three seconds. To quit the Easy Timer setting mode without changing any settings, press the EASY TIMER knob repeatedly until the t indicator appears in the display window. [. . . ] ⷠMake sure the tape is not at its end. Check that the safety tab has not been removed. Make sure your timer settings are past the current time. The clock stops if the VCR is disconnected from the mains for more than eight hours. [. . . ]