User manual SONY SLV-L52

[. . . ] Check that the unit's operating voltage is identical with your local power supply. ⷠIf anything falls into the cabinet, unplug the unit and have it checked by qualified personnel before operating it any further. ⷠThe unit is not disconnected from the mains as long as it is connected to the mains, even if the unit itself has been turned off. ⷠUnplug the unit from the wall outlet if you do not intend to use it for an extended period of time. [. . . ] ⷠThe indicator flashes in the display window when you complete the setting in step 9 with no tape inserted. ⷠIf you set the clock using the Auto Clock Set function* and AUTO ADJUST is set to ON, the clock will adjust itself to the incoming time signal regardless of adjustments made with the Dial Timer. The station name* may not appear if the VCR does not receive station name information signals. The Dial Timer function has a Demonstration Mode that allows the user, such as a salesperson, to enter more than eight examples of timer settings when demonstrating the use of the Dial Timer. It cancels the FULL notice which appears if eight programmes have already been set. Do not use the Demonstration Mode for making timer recordings. Doing so may cause the settings to be inaccurate. to activate the Demonstration Mode Press X (pause) on the VCR while turning the DIAL TIMER. "DEMO" appears in the display window for a few seconds. to cancel the Demonstration Mode Turn the power off and unplug the mains lead. Although the Demonstration Mode is cancelled, the timer settings entered while using the Demonstration Mode will remain. To use the VPS/PDC function, set VPS/PDC to ON in step 4 above. You can also use the VPS/PDC function for a source connected to one or more of the LINE inputs. To record satellite broadcasts If you connect a satellite tuner and the VCR, you can record satellite programmes. 3 satellite tuner finishes recording 4 Keep theprogramme for turned on until the VCR timer setting. The satellite which you have made a To use the VCR after setting the timer To use the VCR before a recording begins, just press ?You can also do the following tasks while the VCR is recording: · To set the programme position, you can also use the PROG +/­ or programme number buttons. ⷠTo set the programme position with a two digit number, press - (ten's digit) button followed by the programme number buttons. ⷠTo set the line input video source, you can also use the PROG +/­ buttons. ⷠTo set the tape speed, you can also use the SP/LP button. ⷠWhen you are recording a programme in the SP mode and the remaining tape becomes shorter than the recording time, the tape speed is automatically changed to the LP mode. Note that some interference will appear on the picture at the point the tape speed is changed. [. . . ] ⷠIf the reception is poor, the VPS/PDC signal might be altered and the VCR might not start recording. The SYNCHRO REC button turns off while recording or does not go back to recording standby mode. You cannot watch Canal Plus programmes when the VCR is in standby mode. If the settings for timer recordings and Synchronized Recording overlap, the programme that starts first has priority and the second programme starts recording only after the first programme has finished. [. . . ]