User manual SONY SLV-SE10AE2

[. . . ] Also, use of this recorder with cable television transmission may require authorization from the cable television transmitter and/or programme owner. Check that the unit's operating voltage is identical with your local power supply. If anything falls into the cabinet, unplug the unit and have it checked by qualified personnel before operating it any further. The unit is not disconnected from the mains as long as it is connected to the mains, even if the unit itself has been turned off. [. . . ] If, however, the picture is not clear, you may also use the manual tuning function. Press PROG +/­ to select the programme position for which you cannot obtain a clear picture. // to get a clearer picture, then press OK. The menu disappears automatically if you don't proceed for more than a few minutes. Turn on your TV and set it to the video channel. The VCR turns on and starts playing automatically if you insert a tape with its safety tab removed. To Stop play Pause play Press p STOP P PAUSE PLAY FF during stop REW during stop To replay a recently watched scene You can immediately rewind and play back the scene you want to watch again. during playback , press REPLAY up to four times. The VCR rewinds the tape about 10 seconds on the counter for each press of the button, and restarts playback. To play an NTSC-recorded tape Set NTSC PB at the rear of the VCR according to the colour system of your TV. When your TV is PAL only PAL and NTSC Set NTSC PB to ON PAL TV NTSC 4. notes · The display does not appear during still (pause) mode or slow-motion playback. The display will not appear while playing an NTSC-recorded tape. If a tape has portions recorded in both PAL and NTSC systems, the time counter reading will not be correct. This discrepancy is due to the difference between the counting cycles of the two video systems. When you insert a non-standard commercially available tape, the remaining time may not be correct. If you play back the tape for about 30 seconds after the tape is inserted, the remaining time will be displayed. You can preset up to eight programmes at a time. Insert a tape with its safety tab in place. Make sure the tape is longer than the total recording time. Turn on your TV and set it to the video channel. Set the date, start and stop times, programme position and tape speed (SLVE480EE only): 1 Press > /. [. . . ] The clock has stopped and "­:­ ­" lights in the display window. The playback picture does not appear on the TV screen. Turn the power off, unplug the mains lead and leave the VCR to dry for over one hour. The clock stops if the VCR is disconnected from the mains for more than an hour. [. . . ]