User manual SONY SLV-SE210G

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Mains lead must only be changed at a qualified service shop. Notice for customers in the United Kingdom and Republic of Ireland A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. If the 13A fitted plug does not match the outlet socket in your home, please refer to your Appointed Sony Dealer for advice. [. . . ] For two-digit numbers, press the - (ten's digit) button followed by the programme number buttons. ⷠIf you connect additional equipment to an input connector, you can select the input signal using the INPUT SELECT or PROG +/­ buttons. ⷠThe DISPLAY information appears on the TV screen indicating information about the tape, but the information won't be recorded on the tape. ⷠIf you don't want to watch TV while recording, you can turn off the TV. ⷠThe remaining tape length may not be indicated accurately for short tapes such as E-20 or E-30, or tapes recorded in the LP mode. The DISPLAY information does not appear during pause mode and the various speeds of playback mode. However, it will appear during normal playback. ⷠIf a tape has portions recorded in both PAL and NTSC systems, the time counter reading will not be correct. This discrepancy is due to the difference between the counting cycles of the two video systems. ⷠWhen you insert a non-standard commercially available tape, the remaining time may not be correct. About 30 seconds after the tape begins playback, the tape remaining time will be displayed. Just enter the PlusCode number listed in the TV programme guide. The date, times, and programme position of that programme are set automatically. You can preset a total of six programmes, including settings made with other timer methods. Insert a tape with its safety tab in place. Make sure the tape is longer than the total recording time. ⷠTurn on your TV and set it to the video channel. Press the programme number buttons to enter the PlusCode number. If you make a mistake, press CLEAR and re-enter the correct number. The programme position, date, start and stop times, tape speed, and VPS/PDC setting appear on the TV screen. If "­ ­" appears in the "PR" (programme) column (this may M E NU happen for local broadcasts), you have to set the appropriate programme position manually. press M/m to select the desired programme position. [. . . ] Check that the safety tab has not been removed. make sure a programme has been set for timer recording. Make sure your timer settings are past the current time. The clock stops if the VCR is disconnected from the mains for more than one hour. [. . . ]