User manual SONY SLV-SE230I

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Mains lead must only be changed at a qualified service shop. Notice for customers in the United Kingdom and Republic of Ireland A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS1362, (i. [. . . ] Do not use the Demonstration Mode for making timer recordings. Doing so may cause the settings to be inaccurate. to activate the Demonstration Mode Press X (pause) on the VCR while turning the DIAL TIMER. "DEMO" appears in the display window for a few seconds. to cancel the Demonstration Mode Turn the power off and unplug the mains lead. Although the Demonstration Mode is cancelled, the timer settings entered while using the Demonstration Mode will remain. Be sure to manually cancel the timer settings before you use the Dial Timer or any other timer method after reconnecting the mains lead (see page 55). Just enter the PlusCode number listed in the TV programme guide. The date, times, and programme position of that programme are set automatically. You can preset a total of eight programmes, including settings made with other timer methods. Insert a tape with its safety tab in place. Make sure the tape is longer than the total recording time. ⷠTo record from a satellite or digital tuner, turn it on. ⷠTurn on your TV and set it to the video channel. Press the programme number buttons to enter the PlusCode number. If you make a mistake, press CLEAR and re-enter the correct number. The date, start and stop times, programme position, tape speed and PDC setting appear on the TV screen. If "­ ­" appears in the "PR" S E L E CT : SET : E ND : OK E X I T : M E NU (programme) column (this may happen for local broadcasts), you have to set the appropriate programme position manually. To record from other equipment connected to one or more of the LINE inputs, press INPUT SELECT to display the connected line in the "PR" position. You will only have to do this operation once for the referred channel. If you want to change the date, tape speed and the PDC setting: To record the same programme S E L E CT : SET : every day or the same day every E ND : OK E X I T : M E NU week, see "Daily/weekly recording" on page 47. For details about the PDC function, see "Timer recording with PDC signals" on page 47. [. . . ] ⷠIf you connect this VCR to both the LINE IN and LINE OUT jacks of the other VCR, select the input correctly to prevent a humming noise. ⷠIf the other VCR does not have a Scart (EURO-AV) connector, use an adequate cable instead and connect the cable to the line out jacks of the other VCR. ⷠWhen you connect another VCR to the LINE-3*1 or LINE-2*2 connector, press INPUT SELECT to display "L3"*1 or "L2"*2 in the display window. *1 SLV-SE830G only *2 SLV-SE730G/I and SE230G/I only When recording on this VCR Turn on your TV and set it to the video channel. [. . . ]