User manual SONY SLV-SE630D

[. . . ] Should the fuse in the plug supplied need to be replaced, a 3 AMP fuse approved by ASTA or BSI to BS1362, (i. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. [. . . ] 5 6 When you have finished setting the time, press DIAL TIMER to start the clock. tips · To cancel a Dial Timer setting, press x (stop) on the VCR while you are making the setting. To change the tape speed, press SP/LP before you complete the setting in step 9. If eight programmes have already been set using the VIDEO Plus+ system or the TIMER PROGRAMMING menu, "FULL" appears in the display window for about five seconds. ⷠThe and indicators flash in the display window when you complete the setting in step 9 with no tape inserted. ⷠIf you set the clock using the Auto Clock Set function and AUTO CLOCK is set to ON, the clock will adjust itself to the incoming time signal regardless of adjustments made with the Dial Timer. When the time is set incorrectly, "ERROR" appears in the display window in step 9. You cannot set the tape speed to AUTO using the Dial Timer. The Dial Timer function has a Demonstration Mode that allows the user, such as a salesperson, to enter more than eight examples of timer settings when demonstrating the use of the Dial Timer. It cancels the "FULL" notice which appears if eight programmes have already been set. Do not use the Demonstration Mode for making timer recordings. to stop recording To stop the VCR while recording , press x (stop). Daily/weekly recording In step 4 above, press m to select the recording pattern. Each time you press m, the indication changes as shown below. T W-SU (every Sunday) t 1 month later t (dates count down) t today Timer recording with PDC signals Some broadcast systems transmit PDC (Programme Delivery Control) signals with their TV programmes. These signals ensure that your timer recordings are made regardless of broadcast delays, early starts, or broadcast interruptions. To use the PDC function, set V/P to ON in step 4 above. You can also use the PDC function for a source connected to one or more of the LINE inputs. To record satellite broadcasts If you connect the satellite tuner and the VCR, you can record satellite programmes. Keep the satellite tuner turned on until the VCR finishes recording the 3 satellite programme for which you have made a timer setting. To use the VCR after setting the timer To use the VCR before a recording begins, just press ?You can also do the following tasks while the VCR is recording: · To use the Auto Tape Speed function In step 4 above, press m to select AUTO. [. . . ] Turn the power off and unplug the mains lead. The tape starts playing as soon as it is inserted. the tape is ejected when you press z REC. Check that the PDC time you set is the correct one (there might be a mistake in the TV programme guide). [. . . ]