User manual SONY SLV-SE700B

[. . . ] Also, use of this recorder with cable television transmission may require authorization from the cable television transmitter and/or programme owner. compatible colour systems · Check the colour systems of your VCR using the table below. Check that the unit's operating voltage is identical with your local power supply. ⷠIf anything falls into the cabinet, unplug the unit and have it checked by qualified personnel before operating it any further. [. . . ] Make sure the tape is longer than the recording time. Set the recording stop time in the same way as in step 2, then press the EASY TIMER knob. Turn the EASY TIMER knob clockwise or counterclockwise to select the programme you want to record. When "­:­ ­" is displayed in the display window, the VCR clock has not been set. You need to set the clock using the Easy Clock function before setting the timer. You can also change the current time using the Easy Clock function. When "­:­ ­" is displayed in the display window, press the EASY TIMER knob. ⷠTo change the clock setting, press and hold the EASY TIMER knob on the VCR for more than three seconds. To quit the Easy Timer setting mode without changing any settings, press the EASY TIMER knob repeatedly until the t indicator appears in the display window. To set the timer and clock setting using the remote commander You can also use the remote commander to set the Easy Timer and Easy Clock. the operations on the VCR and the remote commander correspond as follows: To Confirm the setting and go to the next setting Change the time by 15 minutes (in START/STOP mode) Do this on the VCR Do this on the remote commander Press EASY TIMER knob Press EASY TIMER Turn EASY TIMER knob or hold PROGRAM +/­ down Hold PROG +/­ down You can also use the programme number buttons to set the clock, start and stop times, and the programme you want to record. Insert a tape with its safety tab in place. Make sure the tape is longer than the total recording time. ⷠTurn on your TV and set it to the video channel. Press the programme number buttons to enter the G-CODE number for the programme you want to record. If you make a mistake, press CLEAR and re-enter the correct number. To record Only once Everyday Monday to Friday Once a week Select ONCE DAILY WEEKLY The date, start and stop times, programme position, and tape speed appear on the TV screen. Each press increases or decreases the stop time by five minutes up to one hour. To enter another setting, repeat steps 1 to 4. To record satellite broadcasts When you connect the satellite tuner and the VCR, you can record satellite programmes using the G-CODE number if applicable. On the satellite tuner, select the satellite programme for which you wish to make a timer setting. repeat the steps described on page 43 and page 44. [. . . ] ⷠCheck that the safety tab has not been removed. ⷠMake sure the tape is not at its end. Check that the safety tab has not been removed. Make sure your timer settings are past the current time. [. . . ]