User manual SONY SLV-SE700G

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Mains lead must only be changed at a qualified service shop. Notice for customers in the United Kingdom and Republic of Ireland A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. If the 13A fitted plug does not match the outlet socket in your home, please refer to your Appointed Sony Dealer for advice. [. . . ] To record from another source connected to one or more of the LINE inputs, press INPUT SELECT to display the connected line in the "PROG. You will only have to do this operation once for the referred channel. If you want to change the date, tape speed, and the VPS/PDC setting: 1 Press </, to highlight the item you want to change. To record the same programme every day or the same day every week, see "Daily/weekly recording" on page 50. For details about the VPS/PDC function, see "Timer recording with VPS/ PDC signals" on page 50. To record from another source, leave the connected equipment switched on. to stop recording To stop the VCR while recording , press x STOP. Daily/weekly recording In step 4 above, press m to select the recording pattern. Each time you press m, the indication changes as shown below. T MON (every Monday) t SUN (every Sunday) t 1 month later t (dates count down) t TOMORROW t TODAY Timer recording with VPS/PDC signals Some broadcast systems transmit VPS (Video Programme System) or PDC (Programme Delivery Control) signals with their TV programmes. These signals ensure that your timer recordings are made regardless of broadcast delays, early starts, or broadcast interruptions (when the VPS or PDC indicator in the display window is lit). To use the VPS/PDC function, set VPS/PDC to ON in step 4 above. You can also use the VPS/PDC function for a source connected to one or more of the LINE inputs. To record a programme from your set top box If you connect a set top box and the VCR, you can record a programme from your set top box. 2 On the set top box, select the programme for which you want to make a timer setting. Turned on until the 4 Keep the set top boxmade a timer setting. vCR finishes recording the programme for which you have To use the VCR after setting the timer To use the VCR before a recording begins, just press ?You can also do the following tasks while the VCR is recording: · To set the programme position, you can also use the PROG +/­ or programme number buttons. To set the programme position with a two digit number, press - (ten's digit) button followed by the programme number buttons. To set the line input video source, you can also use the PROG +/­ buttons. To set the tape speed, you can also use the SP/LP button. When you are recording a programme in the SP mode and the remaining tape becomes shorter than the recording time, the tape speed is automatically changed to the LP mode. [. . . ] The clock stops if the VCR is disconnected from the mains for more than one hour. Turn the power off and unplug the mains lead. Check that the VPS/PDC time you set is the correct one (there might be a mistake in the TV programme guide). If the broadcast you wanted to record did not send the good VPS/PDC information, the VCR will not start recording. [. . . ]