User manual SONY SLV-SE710B

[. . . ] , marked with 2 or @ mark) must be used. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. [. . . ] Be sure to set the COMMAND MODE selector on each VCR to a different position to operate each VCR independently. If the COMMAND MODE selector on a VCR is set to OFF, you cannot control that VCR with the remote commander. If the COMMAND MODE selector on this unit is set to OFF, although you cannot control the unit`s VCR with the remote commander, MASTER VOL +/­, MUTING, and the function buttons on the remote commander can operate the unit. *1 The selector 's name on the unit is VTR COMMAND MODE, however, it is described as COMMAND MODE in these Operating Instructions for the sake of convenience. If a VCR has no COMMAND MODE selector, set COMMAND MODE on the remote commander in the following way. If you have another VHS format VCR, set COMMAND MODE on the unit to VTR1 or VTR2. If the TV doesn't turn on, turn it on manually. Press VHS TUNER again if connected with a EURO-AV (Scart) cable. Turning on and controlling another VCR 1 Set COMMAND MODE on the remote commander to the same position as COMMAND MODE on the other VCR. If the other VCR doesn't have a COMMAND MODE selector, set COMMAND MODE on the remote commander according to the table in "Controlling a VCR which has no COMMAND MODE selector" on the previous page. 2 Press VIDEO1, VIDEO2, or VHS LINE depending on which jacks the other VCR is connected to. To control the volume, lift the top cover of the remote commander and press TV VOL +/­. Press u while the remote commander is in TV control mode. 2 Select the preset number by pressing the number buttons. Press and hold this button to keep changing the preset numbers. To use the tuner with the A, B, and C categorization system Each press changes the preset number as follows: Press and hold this button to keep changing the preset numbers. The unit turns on and switches the input source to the CD player connected to the CD jacks. 2 Press 6 OPEN/CLOSE to open the disc tray. If the disc tray or cover doesn't open, refer to your CD player's operating instructions. 3 Load a CD or CDs referring to your CD player 's operating instructions. 4 Press 6 OPEN/CLOSE to close the disc tray. If the disc tray or cover doesn't close, refer to your CD player's operating instructions. [. . . ] make sure a programme has been set for timer recording. Make sure you press TIMER REC ON/OFF to set the unit to timer recording standby. Make sure the current time has not already passed your timer settings. The clock stops if the unit is disconnected from the mains for more than one hour. [. . . ]