User manual SONY SLV-SE720N

[. . . ] Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS1362, (i. , marked with 2 or @ mark) must be used. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. [. . . ] (ten's digit) button followed by the programme number buttons. You can select a video source from the LINE-1 (TV) connector, the LINE-2 IN jacks, or the LINE-3 IN (Scart) connector also using the INPUT SELECT button. The display appears on the TV screen indicating information about the tape, but the information won't be recorded on the tape. If you don't want to watch TV while recording, you can turn off the TV. notes · The display does not appear during still (pause) mode or slow-motion playback. The display will not appear while playing an NTSC-recorded tape. If a tape has portions recorded in both PAL and NTSC systems, the time counter reading will not be correct. This discrepancy is due to the difference between the counting cycles of the two video systems. When you insert a non-standard commercially available tape, the remaining time may not be correct. About 30 seconds after the tape begins playback, the tape remaining time will be displayed. Recording what you are watching on the TV (TV Direct Rec) If you use the SMARTLINK connection, you can easily record what you are watching on the TV (other than tapes being played on the VCR). Daily/weekly recording In step 4 above, press . N MON (every Monday) n SUN (every Sunday) n 1 month later n (dates count down) n TOMORROW n TODAY Timer recording with VPS/PDC signals Some broadcast systems transmit VPS (Video Programme System) or PDC (Programme Delivery Control) signals with their TV programmes. These signals ensure that your timer recordings are made regardless of broadcast delays, early starts, or broadcast interruptions (with the VPS or PDC indicator in the display window lit). To use the VPS/PDC function, set VPS/PDC to ON in step 4 above. You can also use the VPS/PDC function for a source connected to the LINE-1 (TV) connector, the LINE-2 IN jacks, and the LINE-3 (Scart) connector. To record satellite broadcasts If you connect the satellite tuner and the VCR, you can record satellite programmes. On the satellite tuner, select the satellite programme for which you want to make a timer setting. Keep the satellite tuner turned on until the VCR finishes recording the satellite programme for which you have made a timer setting. To use the VCR after setting the timer To use the VCR before a timer recording begins, just press I/u. the indicator turns off and the VCR switches on. Remember to press I/u to reset the VCR after using the VCR. [. . . ] Clean the video heads using the Sony T-25CLD, E-25CLDR, or T-25CLW video head cleaning cassette. If these cleaning cassettes are not available in your area, have the heads cleaned at your nearest Sony service facility (a standard service charge will be required). Do not use a commercially available liquid type cleaning cassette other than Sony's, as it may damage the video heads. Consult your local Sony service facility for more information. [. . . ]