User manual SONY SLV-SE737E

[. . . ] Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI or mark) to BS1362, (i. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. [. . . ] You can preset up to eight programmes at a time. Insert a tape with its safety tab in place. Make sure the tape is longer than the total recording time. ⷠTurn on your TV and set it to the video channel. Press the programme number buttons to enter the PLUSCODE NO. If you make a mistake, press CLEAR and re-enter the correct number. The date, start and stop times, programme position, tape speed, and VPS/PDC setting appear on the TV screen. if "­ ­" appears in the "PROG. " (programme) column (this may happen for local broadcasts), you have to set the appropriate programme position manually. Then enter a three digit channel number with the number buttons. You will only have to do this operation once for the referred channel. ⷠThe indicator flashes in the display window when you press ?When you set TIMER OPTIONS to STANDARD in the OTHER OPTIONS menu, the VIDEO Plus + menu does not appear on the TV screen. If the VIDEO Plus + system is not available in your area, follow the instructions below to set the timer to record programmes. Insert a tape with its safety tab in place. Make sure the tape is longer than the total recording time. ⷠTo record from a decoder or other source, turn it on. ⷠTurn on your TV and set it to the video channel. Set the date, start and stop times, programme position, tape speed, and VPS/PDC function: 1 Press , to highlight each item in turn. To correct a setting, press < to return to that setting and reset it. To record the same programme every day or the same day every week, see "Daily/weekly recording" on page 57. For details about the VPS/PDC function, see "Timer recording with VPS/PDC signals" on page 53. [. . . ] Remote commander S18 The remote commander does not operate. T Make sure you are pointing the remote commander at the remote sensor on the VCR. T Replace all of the batteries in the remote commander with new ones if they are weak. The code number may change when you replace the batteries for the remote commander (see page 8). [. . . ]