User manual SONY SLV-T2000MN

[. . . ] Accessories supplied 4 Adjusting picture 50 tracking 50 Aerial hookup 9 AFT (Auto Fine Tuning) 21 ATP 14 Audio track 48 Audio dubbing 57 Recording 31 bilingual programmes 46 saving 33 stereo programmes 46 using G-CODE 35 While watching another programme 33 Remote commander 5 RF channel 12 Cancelling timer settings 44 Changing timer settings 44 Cleaning the video heads 62 Clock setting 27 Colour system 2 Connecting the VCR and your TV 9 to a stereo system 11 to a TV with a EURO-AV connector 10 Counter 30, 32 Monitoring during playback 53 during recording 32 Safety tab 33 Searching at various speeds 41 using the index function 49 SP mode 32 To prevent fire or shock hazard, do not expose the unit to rain or moisture. Check that the unit's operating voltage is identical with your local power supply. If anything falls into the cabinet, unplug the unit and have it checked by qualified personnel before operating it any further. The unit is not disconnected from the mains as long as it is connected to the mains outlet, even if the unit itself has been turned off. [. . . ] Remember to press TIMER REC ON/OFF to reset the VCR after using the VCR. You can also do the following tasks while the VCR is recording: · If the VCR beeps repeatedly, this means that: ­ The G-CODE number is incorrect. ONCE , DAILY , or WEEKLY was selected incorrectly. You cannot select DAILY or WEEKLY for a programme that airs more than seven days ahead. You cannot set the timer recording on both the 8 mm deck and VHS deck, since you have to select the deck before you make the setting. While one deck is standing by for timer recording or proceeding timer recording, another deck can only play back a recorded tape and record the line input source. If G-CODE is not available in your area, follow the instructions below to set the timer to record programmes. You can preset up to eight programmes at a time. Insert a VHS tape with its safety tab in place or an 8 mm tape with the safety switch slid so that the red portion does not show. Make sure the tape is longer than the total recording time. Turn on your TV and set it to the video channel. When using a decoder or a satellite tuner, turn it on. Press either Video8 or VHS which is set in the SET UP MENU. Set the date, start and stop times, programme position, and tape speed (VHS deck only) : 1 Press CURSOR / to highlight each item in turn. To record the same programme every day or the same day every week, press CURSOR . If you want to use the VPS/PDC function, press CURSOR > /. to turn on V/P in the " V/P " position. For details, see "Timer recording with VPS/PDC signals" on the next page. To enter another setting, move the cursor to the next line and repeat step 3. To record from a decoder or other source, leave the connected equipment switched on. N EVERY MON n EVERY SUN n 1 month later n (dates count down) n the current date Timer r ecor ding with VPS/PDC signals The broadcast systems transmit VPS (Video Programme System)(SLVT2000AS only) or PDC (Programme Delivery Control) signals with its TV programmes. These signals ensure that your timer recordings are made regardless of broadcast delay, early starts or broadcast interruptions. [. . . ] the tape is ejected when you press r REC. Check that the safety tab of the VHS has not been removed, or that the safety switch of the 8 mm tape has not been slid to show the r ed por tion. Make sur e the tape is not at its end. Select a pr ogramme position when r ecording TV programmes; select "L1" or "L2" when r ecording from other equipment. [. . . ]