User manual SONY SLV-X9G

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Mains lead must only be changed at a qualified service shop. Notice for customers in the United Kingdom and Republic of Ireland A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. If the 13A fitted plug does not match the outlet socket in your home, please refer to your Appointed Sony Dealer for advice. [. . . ] These signals ensure that your timer recordings are made regardless of broadcast delays, early starts, or broadcast interruptions (when the VPS or PDC indicator in the display window is lit). To use the VPS/PDC function, set VPS/PDC to ON in step 4 above. You can also use the VPS/PDC function for a source connected to one or more of the LINE inputs. To use the VCR after setting the timer To use the VCR before a recording begins, just press ?You can also do the following tasks while the VCR is recording: · To set the programme position, you can also use the PROG +/­ or programme number buttons. ⷠTo set the programme position with a two digit number, press - (ten's digit) button followed by the programme number buttons. ⷠTo set the line input video source, you can also use the PROG +/­ buttons. ⷠTo set the tape speed, you can also use the SP/LP button. ⷠWhen you are recording a programme in the SP mode and the remaining tape becomes shorter than the recording time, the tape speed is automatically changed to the LP mode. Note that some interference will appear on the picture at the point the tape speed is changed. If you want to keep the same tape speed, set AUTO LONG PLAY to OFF in the OPTIONS-1 menu (see page 84). ⷠTo check, change, or cancel the programme setting, press </, to choose LIST, then press OK in step 4. If the VPS/PDC signal is too weak or the broadcasting station failed to transmit VPS/PDC signals, the VCR will start recording at the set time without using the VPS/PDC function. ⷠThe indicator flashes in the display window when you press ?When you set TIMER OPTIONS to STANDARD in the OPTIONS-2 menu, the VIDEO Plus+ menu does not appear on the TV screen. The station name may not appear if the VCR does not receive station name information signals. You can preset a total of eight programmes, including settings made with other timer methods. Insert a tape with its safety tab in place. Make sure the tape is longer than the total recording time. ⷠTurn on your TV and set it to the video channel. Set the date, start and stop times, programme position or station name, tape speed, and VPS/PDC function: 1 Press , to highlight each item in turn. To correct a setting, press < to return to that setting and reset. [. . . ] Re-enter the brand code number corresponding to your Set-Top Box (see page 25). You cannot watch the STB picture when the VCR is in standby mode or recording standby mode. Make sure you are pointing the remote commander at the remote sensor on the VCR. ⷠReplace all the batteries in the remote commander with new ones if they are weak. [. . . ]