User manual SONY SL-V760HF

[. . . ] The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. installing · Do not install the unit in a confined space such as a book or similar unit. Do not install the unit in an inclined position. Keep the unit and discs away from equipment with strong magnets, such as microwave ovens, or large loudspeakers. [. . . ] Make sure the tape is longer than the total recording time. If the DVD player is in play mode, you cannot display the setup menu. If you want to change a setting, go on to the next step. If you do not need to change the settings, press SET UP to exit the menu. If any settings remain, turn off the VCR to return to recording standby. When the timer settings overlap The programme that starts first has priority and the second programme starts recording only after the first programme has finished. if the programmes start at the same time , the programme listed first in the menu has priority. Programme 1 Programme 2 will be cut off Programme 1 Programme 2 about 20 seconds will be cut off about 20 seconds A Use this hookup if your A/V receiver has a Dolby* Surround (Pro Logic) decoder and 3 to 6 speakers You can enjoy the Dolby Surround effects only when playing Dolby Surround audio or multi-channel audio (Dolby Digital) discs. B Use this hookup if your A/V receiver has a Dolby Digital, MPEG audio or DTS* decoder, a digital input jack and 6 speakers This connection will allow you to use the Dolby Digital, MPEG audio or DTS decoder function of your AV amplifier (receiver). You are not able to enjoy the surround sound effects of this player. You must make connections using B-1 and B-2 . However, if the signal is encrypted for copyright protection purposes, the signal is only output as 48 kHz/16 bit. If you select the surround setting while playing a DVD, the player does not output the following signals from the DIGITAL AUDIO OUT (OPTICAL or COAXIAL) jack. Dolby Digital signals (when you set "Dolby Digital" to "D-PCM" in "AUDIO SETUP" menu) ­ MPEG audio signals · If you connect a component that does not conform to the selected audio signal, a loud noise (or no sound) will come out from the speakers, affecting your ears or causing the speakers to be damaged. Even if you set "48kHz/96kHz PCM" to "96kHz/24bit", the sampling frequency is converted to 48 kHz/16 bit when a "SURROUND" mode (page 78) is selected. The analog audio signals from AUDIO OUT L/R jacks are not affected by "48kHz/96kHz PCM" setting and keep their original sampling frequency level. "Screen Setup" allows you to set the screen according to the playback and connection conditions. Press SET UP when the DVD player is in stop mode, then press V/v to select (DVD) and press ENTER. 4:3 Letter Box 4:3 Pan Scan Select this when you connect a 4:3 screen TV. Displays a wide picture with bands on the upper and lower portions of the screen. Select this when you connect a 4:3 screen TV. Automatically displays the wide picture on the entire screen and cuts off the portions that do not fit. [. . . ] Others The selected input line connector number does not appear in the display window. Clean the cabinet, panel and controls with a dry, soft cloth, or a soft cloth slightly moistened with a mild detergent solution. Do not use any type of solvent, such as alcohol or benzine. No picture (or black & white screen appears) Chapter (page 31) Sections of a picture or a music feature that are smaller than titles. [. . . ]