User manual SONY SMS1P

[. . . ] Remove the protective cover after you have connected the speaker and placed it in its final position. â· When listening at large volumes, we recommend keeping the sound at a level where it does not distort. â· To prevent damage to the speaker unit, be sure to attatch the supplied protective cover when moving the speaker or placing it in storage. Check that there is no other source of magnetism* near the TV set. [. . . ] * Examples of sources of magnetism: Rack, magnets attached to secure the doors of the TV stand, health tools, magnets used with a toy, etc. Do not install the speaker near heat sources such as radiators or air ducts, or in a place subject to direct sunlight, excessive dust, mechanical vibration or shock. â· Good ventilation is essential to prevent internal heat buildup in the speaker. place the speaker in a location with adequate air circulation. Do not place the speaker on a soft surface or too close to a wall as this may obstruct the ventilation hole on the back. Before operating the speaker, be sure that the operating voltage of your speaker is identical with that of your local power supply. â· Unplug the speaker from the wall outlet if it is not to be used for an extended period of time. Should any liquid or solid object fall into the speaker, unplug the speaker and have the speaker checked by qualified personnel before operating it any further. â· AC power cord must be changed only at the qualified service shop. Clean the cabinet with a soft cloth lightly moistened with water. (Before turning the power ON, be sure the MASTER VOL. Or Canada, 220-230 V in Europe) using the supplied power cord. Press if the pilot lamp on the front panel does not light when the power is turned on. This resets the power supply so you can use the speaker. Use to input an external sound source directly to the speaker's power amp. Use this terminal to input sound output to an effector, or when connecting several speakers. Turning to the right increases the level of the sound output from the speaker. Allows you to output a mix of the sounds input to channel 1 and channel 2. Use to output sound when connecting several speakers. Turn to the right to increase the level of the bass. [. . . ] Turn to the left to decrease the level of the bass. (Increasing the level of the bass when listening at high volumes may cause the sound to distort. Input terminal) Setting this switch to DIRECT allows you to bypass the tone controls and send the sound from a mixer (etc. ) directly to the speaker's power amplifier. [. . . ]