User manual SONY SPK-AZ1 ANNEXE 1

[. . . ] ˎ The waterproof performance is based on the testing standards of our company. ˎ Do not subject this unit to pressurized water, such as from a tap. ˎ Use this unit in the recommended operating water temperature range of −5 °C to +40 °C (23 °F to +104 °F). [. . . ] We recommend this unit be inspected at an authorized repair shop (chargeable). ˎ You cannot operate the REC button when the REC HOLD switch is set to the HOLD position. Release the REC HOLD switch before operation. (See illustration -a) ˎ The field of view will be slightly narrowed when you use this unit. ˎ Since the camera fails to focus underwater, it is not suitable to shoot images underwater. ˎ You can record audio while the camera is in this unit, but the sound level is reduced. ˎ Thread a suitable cord through the attachment hole of this unit, then attach the cord to an item you intend to use with the camera. ˎ When inserting the camera in this unit body, if the cord detaches from the case cover, attach it again. ˎ When inserting the camera in this unit body, release the REC HOLD switch on the camera. Failure to do O-ring maintenance according to the instructions may lead to water leaks and cause this unit to sink. Őを発見した場合は、 ただちにご使用を中止してソニーの相談窓口にお問い合わ せください。 ˎ Carefully check that there is any dirt, sand, hair, dust, salt, threads, etc. If found, be sure to wipe off with a soft cloth. ˎ Be careful not to leave any cloth fibers on the O-ring after wiping it. ˎ Check the O-ring for cracks, skewing, distortion, fine splitting, scratches, embedded sand, etc. Replace the O-ring if you find any of these. ˎ Inspect the O-ring contact surface on the case body in the same way. Âますので避けてく ださい。 Before installing the camera, always close this unit and immerse it in water to make sure no water leaks in. When finding a malfunction of Waterproof Case If a malfunction is found by inspection of the O-ring or check for water leaks, stop using this un t immediately and take it to the nearest Sony dealer. [. . . ] When finding a malfunction of Waterproof Case If a malfunction is found by inspection of the O-ring or check for water leaks, stop using this un t immediately and take it to the nearest Sony dealer. Maintenance Be sure to perform the above maintenance each time you use this unit. Do not use any type of solvent such as alcohol, benzine or thinner for cleaning, as this might damage the surface finish of this unit. [. . . ]