User manual SONY SPK-WA annexe 1

[. . . ] The model and serial numbers are located inside of the unit. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Do not subject the front glass to strong shocks, as it may crack. [. . . ] To use the camera again, leave it in the cool place for a while to cool down. Do not use the case in depths below 3 m (10 feet). If sun oil is on this unit, be sure to wash it off thoroughly using lukewarm water. If this unit is left with sun oil on its surface, this unit may discolor or become damaged (such as cracks forming in the surface). [UNDERWATER WHITE BALANCE] is not available when the flash is set to [Flash On]. ) Notes When using the flash with this unit attached, the shooting distance may decrease or the left side of the screen may darken. If you do not attach the diffuser that the screen may darken, when using the flash with this unit attached. Reflected glare may occur depending on the shooting condition. if this happens , change the condition. If you do not operate the camera with the power on for a certain time, the camera turns off automatically to prevent the battery pack from wearing down. To use the camera again, turn on the power again. Clean the inside of this unit with a soft dry cloth. Avoid storing the case in a cold, very hot or humid place, or together with naphthalene or camphor, as these conditions might damage the unit. Be sure to perform the above maintenance each time you use this unit. Do not use any type of solvent such as alcohol, benzine or thinner for cleaning, as this might damage the surface finish of this unit. Notes Before opening this unit, rinse it with tap water or fresh water and then wipe the water off with a soft cloth. When opening it, be careful not to let any water from your body or hair onto the camera. Symptom There are drops of water that inside the front glass of this unit or that on the LCD screen of the camera. cause/Corrective Actions The hard case is not placed correctly. Correctly mount again the hard case, after check that the jacket case opening is fitted correctly to the hard case opening. If found, wipe off with a soft cloth or tissue paper. Insert another "Memory Stick Duo" media or erase unneeded data from the "Memory Stick Duo" media. [. . . ] Notes Check the jacket case opening that is not any dirt, sand, hair, when you close the hard case. A water leak may develop if the parts are not tightly fit. If you install the camera DSC-W290, you cannot see verge of the LCD screen. Because the LCD screen of camera DSC-W290 is large more than the jacket case opening. [. . . ]