User manual SONY SPK-WB

[. . . ] Before using the camera underwater, check around the jacket case opening (-) that there is no dirt, sand, hair, dust, salt, thread, cracks, skewing, or scratches. Do not scratch the jacket case opening when you store the jacket case. In the unlikely event that a malfunction of this unit causes damage due to water leakage, Sony does not guarantee against damages to the equipment contained in it (camera, battery pack, etc. ) and the recorded contents, nor will bear any expenses relating to the captured photographs. [. . . ] Playing back with the control button You can play back images on the LCD screen using the control button. Always be sure to turn off the power when installing or removing the camera. The lens may be damaged if the power is on. Be careful not to drop the camera when removing it. If water happens to leak in, take it out of the water immediately. If the camera gets wet, take it to the nearest Sony dealer immediately. Coat the surface of the glass with the supplied anti-fogging lens solution. This is effective in preventing from fogging. How to use the anti-fogging lens solution Apply 2 or 3 drops of the liquid to the front glass and wipe evenly to spread the liquid out by using the swabs, a soft cloth or tissue paper. 2 Firmly hold the body of this unit in the direction of the arrow and release the buckle in the following sequence: , . (-2) 3 Turn the front of the hard case upwards before opening the rear of the hard case. (-3) 4 Turn this unit downward with the rear of the hard case open, and remove the camera together with the jacket case. (-4) 5 Remove the camera from the jacket case. (-5) 6 Cancel the mode if you may set (Underwater) in mode for underwater still image or (Underwater) in mode for underwater movie recording. If you open the hard case with the front facing down, drops of water may get onto the LCD screen of the camera. Do not directly press the front glass of this unit. When the camera has been used for a long time, the camera heats up. Turn off the power and allow it to cool before removing the camera from this unit. After recording in a location with a sea breeze, wash this unit thoroughly in fresh water with the buckles fastened to remove salt and sand, then wipe with a soft dry cloth. It is recommended that you submerge this unit in fresh water for about 30 minutes. If it is left with salt on it, metal portions may be damaged or rust may form and cause water leakage. If sun oil is on this unit, be sure to wash it off thoroughly using lukewarm water. [. . . ] ) (sports pack only) Included items Jacket case (1) Lens/LCD cover (1) Hand strap (1) Anti-fogging lens solution (1) Diffuser (1) Float (1) Set of printed documentation Design and specifications are subject to change without notice. We recommend attaching the hand strap (supplied) before using this unit. notes The float attached to the hand strap is for preventing loss of the case underwater. If you use as the sports pack, use the hand strap with the float attached. [. . . ]