User manual SONY SPM-TRIC INSTALLATION & CONNECTIONS

[. . . ] ® INSTALLATION MANUAL Sony Electronics Inc. 16450 West Bernardo Drive San Diego, CA 92127 www. sony. com/plasma Contents o o o o o o Safety & precautions Mount diagrams Parts List Building the stand Securing the plasma to the stand Tabletop fixed installation (optional) Safety & Precautions WARNING: Safety precaution measures must be practiced at all times during the installation of this product. [. . . ] Fixed tabletop mounting holes Dimensions are in Inch and mm 18. 25 (463. 5) 20. 50 (520. 7) 20. 00 (508) 1. 00 (25. 4) 12 X 22 (304 x 558) (A) MODEL PFM-32C1 FWD32LX1, FWD32DV1 PFM-42B1, PFM-42V1, FWD42X1 PFM-42LX1, FWD42DV1 PFM-50C1 PFM-50DV1 A . 37 1. 0 . 72 1. 0 . 90 1. 0 (9. 4) (25. 4) (18. 2) (25. 4) (22. 8) (25. 4) -3- Parts List TOOLS & SUPPLY NEEDED HARDWARE Phillips screwdriver (4) M5 x 10 (mm) flat head Phillip screws (4) Clear rubber feet (6) M5 x 30 (mm) flat head Phillip screws (2) M6 x 30 Phillips head screws (used on the 30" plasma only) (2) M5 x 12 (mm) phillip security screws (used on 42" and 50" plasma displays only) (2) #10 x 1-3/4" wood screws (Optional use) Building the stand Step 1 Unpack the components from the box and set them on the floor. Invert and apply the four (4) clear rubber feet to the flat surface on the base, locate the four mounting points on the clear base. Secure the two (2) upright supports (flat surface facing out) to the base by using the four (6) M5 x 30 (mm) Phillip screws (supplied). CAUTION: Do not over tighten the screws. Uprights Clear base (6) M5 x 30 Flat head screws Step 2 The stand fits a 32" 42" and 50" PFM series (Sony plasma displays only). The plate is stamped with two plasma sizes. Check the size that fits your plasma before installing. NOTE: If using a 32" plasma, the plate is not needed. Mount the plasma quick release sleeves from the plasma to the key-holes on the uprights. The size and arrow must always point up prior to installation, finger tighten the (4) M5 x 10 (mm) phillips flat head screws then tighten the screws. See figure 2. 50" 42" (4) M5 x 10 Flat head screws Mounting plate -4- Securing the plasma to the stand Step 3 Raise the display with the securing sleeves installed to the plasma. [. . . ] NOTE: Longer or shorter wood screws and or mounting hardware depending on your installation environment are (commercially available). See figure 5. Wood 1-1/4" #10 x screw wood screws access Flat wood surface NOTE: Check all hardware for proper tightness and security. -6- [. . . ]