User manual SONY SPP-A900

[. . . ] 7 hours when you use the handset continuously · Approx. 6 days when the handset is in standby mode. Notes · The battery pack will gradually discharge over a long period of time, even if not in use. · If you leave the battery pack in the handset without charging it, the battery pack will be completely discharged. It may require several times of charging to recover its full capacity. Making calls with speed dialing 1 2 3 Press (TALK/FLASH). [. . . ] The prerecorded greeting will be assigned automatically. · If a call comes in during recording, recording stops automatically. · If 90 seconds have passed or memory becomes full in step 3, recording stops automatically. · "Memory full" is announced if no recording space is available when you press (REC/MEMO). Erase unnecessary messages (see "Erasing messages"). Tip To record a greeting for the "announcement only" mode, select the announcement only mode first (see "Selecting the Announcement Only Mode"), then follow the instructions above. Otherwise, the normal greeting will be recorded. Press a mailbox button ((MAILBOX 1), (MAILBOX 2) or (MAILBOX 3)) to play back new messages in the selected mailbox. microphone (MIC) to record your message. A memo can be up to four minutes in length. The message number on the display increases by one. Notes on power sources On battery pack · Store the battery pack at a temperature between 41°F (5°C) and 95°F (35°C) for best performance. · If you do not use the handset for a long period of time, remove the battery pack after charging for more than 10 hours. This maintains battery life. 4 Press (PLAY/STOP) to stop (PLAY/STOP) (SKIP/QUICK) Notes · If the memory becomes full, the answering machine will stop recording. Please leave your name, number and message after the tone. " 3 Press (TIME/SET) to confirm your 4 Press (PLAY/STOP) to exit the Note Press and hold (SELECT) to increase the remote ID code (security code) by 10. Problem You hear four short error beeps when you press (TALK/FLASH). You hear no dial tone. Solution · Make sure you have set up the base unit correctly. · Move the handset closer to the base unit. · Replace the handset to the base unit for a while to reset the random security code. · Make sure the telephone line cord is securely connected to the telephone outlet. · Make sure the battery is fully charged. Adjusting the speaker volume To adjust the speaker volume, press (VOLUME)(+) or (-). Announcement only mode: "Hello, I'm unable to answer your call right now. Thank you. " The phone does not connect · Make sure the dialing mode is set correctly. at all, even though the number you dial is correct. The phone does not redial · Make sure the last dialed number is really the one you want to dial. · Make sure the ringer is turned on. Charge the battery for more than 10 hours. [. . . ] "Answer machine on" or "Answer machine off" is announced. Turning on the answering function Message counter 3 Press (TIME/SET). Mounting the base unit on the wall 1 Hang-up tab Message counter The message counter on the base unit shows the following information. When the counter shows It means Flashing number Number of messages not yet played back. CL Flashes when the day and time is cleared or delayed due to a power interruption, or when you connect the base unit to the AC outlet for the first time. Erase unnecessary messages. Press (ANSWER ON/OFF) on the base unit. The ANSWER ON/OFF button lights up. 1 Raise the hang-up tab. [. . . ]