User manual SONY SPP-IM982

[. . . ] 3-223-744-11 (1) 2-Line Cordless Telephone Operating Instructions US SPP-IM982 ©2000 Sony Corporation Owner's Record The model and the serial numbers are located at the bottom of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. ________________ 2US IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. [. . . ] The corresponding line button lights up. When you're done talking, press (OFF). To obtain the best speakerphone performance, see page 30. (MUTING) MUTING lamp (HOLD) (VOL) (LINE 1) L1 and L2 RINGER LEVEL switches (LINE 2) (OFF) (CALL WAITING/FLASH) continued Basics 29US Receiving calls (continued) Additional tasks To Adjust the speaker volume Do this During speakerphone conversation, press (VOL)(+) or (--). Each press of (VOL)(+) or (--) switches the speaker volume by one of 8 levels. Adjust the ringer volume of You can adjust the ringer volume of line 1 and 2 the base unit respectively. Set the L1 or L2 RINGER LEVEL switch on the base unit to HIGH, LOW or OFF. The LINE 1 or LINE 2 button will flash slowly. Press (LINE 1) or (LINE 2) to resume the conversation. Press (MUTING) to disable the microphone. Press (CALL WAITING/FLASH) again to return to the first caller. Mute your voice Switch to another call ("call waiting" service*) * You need to subscribe to the service from your telephone company. Note Even when you set the L1 or L2 RINGER LEVEL switch on the base unit to OFF, the handset will ring when the ringer of the handset is turned on (see page 38). Tips · To inform you of an incoming call, the line button lights on and off according to the ring signal even when you set the L1 or L2 RINGER LEVEL switch on the base unit to OFF. · If there is an incoming call while on the intercom, the base unit will ring at a low level even when the L1 or L2 RINGER LEVEL switch on the base unit is set to OFF. To obtain the best speakerphone performance · You may not be able to hear the other party's voice in a noisy place. Therefore, use the speakerphone in a quiet room. · Do not bring your hand or other object too close to the microphone or you will hear a shrill noise ("feedback"). · When the speaker volume is loud, or the base unit has been placed close to a wall, you may find that the volume drops suddenly. This is due to a circuit in the telephone designed to protect against feedback. In such cases, lower the speaker volume slightly. 30US Basics Receiving a call while talking If another call comes in while talking on the other line, the corresponding line button will flash. Example: Receiving a call on line 2 while talking on line 1 1 2 3 Press (HOLD) while talking. The line 1 is put on hold and the LINE 1 button flashes slowly. Now you can talk to another caller on line 2. To put on hold line 2 and resume the conversation on line 1, press (HOLD), and then (LINE 1). or To disconnect line 2 and resume the conversation on line 1, press (LINE 1). Basics Notes · If you do not press (HOLD) in step 1, line 1 will be disconnected. [. . . ] Be sure to answer after the Caller ID data is displayed. · Make sure you have subscribed to "Caller ID with call waiting" service (page 55). · Make sure nobody is talking with another phone on the same telephone line. · Make sure you entered your home area code correctly (page 17). [. . . ]