User manual SONY SRF-DR2000

[. . . ] in this case , preset the stations again. Be sure to take note of your important data that is saved in the memory. â· When you are not going to use your unit for an extended period of time, remove the batteries to prevent possible damage from battery leakage and corrosion. When the radio turns off unexpectedly When you set the Auto Power OFF function to ON, the radio turns off automatically approximately after 120 minutes to prevent unnecessary wear of the batteries. [. . . ] Select the desired menu by pressing the corresponding Function button to receive further information where applicable. The station you tune in to does not transmit FM multiplex information or the reception is weak. Depending on the reception, the audio is received but the data may not be received for FM Data broadcast. Inside buildings or underground areas, the data may not be received or the reception may be poor, and receiving the FM data fully may take a while. When an urgent information is broadcasted while receiving FM Data Broadcast, you will hear a beeping sound through the headphones and the FM Data Broadcast display will automatically switch over to the urgent information. When you receive the urgent information the DATA and MSG indications appear at the left side of the display. To move to the next page, follow the instructions to the contents of the receiving broadcast. When you receive a paging message, you will hear a beeping sound through the headphones and the PAGE indicator will flash at the left side of the display. (There is no incut indication) Press any button to stop the beep. When you display the Paging Message, the PAGE indicator stops flashing and appears. To see a paging message, use BACK to display the selecting window below, and then press the corresponding Function button to PAGE. If there is no data to be received, approximately after 20 seconds the display will return to the previous screen. When the reception is poor, the DATA indicator disappears, but "RECEIVING DATA!" will be displayed for approximately 10 seconds and return to the previous display. To return to the screen one level above You can save up to 8 pages of important information that you can recall for later use. Note If you try to save another page of Memory FULL!Information when 8 pages of Please delete unnecessary data to information have already been saved, the message will be displayed create space!In this case, delete unnecessary data from the saved information. Note If you enter the "Maintenance Mode" at the "Set Up Menu", press BACK to return to previous display. When you turn this to ON and there is no key operation for 120 minutes while the power is turned on, the power automatically turns off. [. . . ] Should any problem occur with the unit, make the following checks to determine whether or not servicing is required. Reception may be poor when there are obstructions such as buildings, etc, or when listening to the radio inside a moving vehicle. Move to another location free of obstacles for optimum reception conditions, or listen to the radio near the window of the moving vehicle. The desired preset station is not received when the corresponding Function button is pressed. [. . . ]