User manual SONY SRF-HM10

[. . . ] The power cannot be turned on, and " display. · The battery has been completely exhausted. " is flashing in the Installing the Battery (See Fig. A) 1 Open the battery compartment lid and install one size AAA (R03) battery (not supplied) observing correct polarity. When a battery is first installed, "AM 12:00" flashes in the display. [. . . ] · In vehicles or buildings, radio reception may be difficult or noisy. · If the Driver units become wet, wipe them with a dry towel before use. · Clean the earbuds by hand-washing with a mild detergent solution. After cleaning, dry the earbuds well before use. Lead-free solder is used for soldering. Halogenated flame retardants are not used in printed wiring boards. Notes on Headphones Road safety Do not use headphones while driving, cycling, or operating any motorized vehicle. It may create a traffic hazard and is illegal in many areas. It can also be potentially dangerous to play your headphones at high volume while walking, especially at pedestrian crossings. You should exercise extreme caution or discontinue use in potentially hazardous situations. Preventing hearing damage Avoid using headphones at high volume. Hearing experts advise against continuous, loud and extended play. If you experience a ringing in your ears, reduce volume or discontinue use. Caring for others Keep the volume at a moderate level. This will allow you to hear outside sounds and to be considerate to people around you. Warning If there is lightning when you are using the unit, take off the headphones immediately. Cautions on Water-Resistance This unit is designed so that it can be used with slight exposure to rain, snow and other forms of moisture, but there are several points on which caution should be observed. · Do not allow it to come in contact with large amounts of water. · If water should get on it or if it should fall into water, take it out immediately and wipe it off with a dry cloth. The interior of the battery compartment has no water-resistance. The battery may corrode, so wipe out the interior of the battery compartment as follows. ­ Open or close the battery compartment with dry hands in a place without exposure to any water. ­ Wipe off the battery and the inside of the battery compartment. Give special attention to the contacts, so that no water remains on them. [. . . ] 2 Press TUNE + or ­ to select the preset number to be deleted. 3 Hold down MODE/ENTER for more than 4 seconds until "P", " " and the preset number flash. P preset number to be deleted 3 Press TUNE + or ­ to select the desired frequency. If you hold down TUNE + or ­, the frequency changes rapidly. When the frequency matches the broadcast frequency, the broadcast will be received. 4 4 Adjust the volume using VOL + or ­. While the letters and the preset number are flashing, press MODE/ ENTER. The station set to the preset number just before the deleted station will be displayed. To delete other stations, repeat steps 2 to 4. [. . . ]