User manual SONY SRF-M607

[. . . ] After selecting the preset number (displayed with "PRESET") set to the radio station, pressing the ENTER/CLOCK deletes the preset station and presets the station being received. Example: Display window when you preset 90. When you press POWER after installing the new batteries, the indicator changes to " ". [. . . ] When you hold down SCAN TUNE/TIME SET + or ­, the digit(s) change rapidly. All the other buttons on the radio will become inoperative. This function prevents the radio from being unintentionally turned on, or the radio frequency from being accidentally changed. After setting the minutes, the clock starts operating, and " : " starts flashing. To set the current time exactly, after setting the minutes and press ENTER/CLOCK with the time signal (such as a radio station). ⷠOnce you start setting the clock, you must perform each step within 65 seconds, or the clock setting mode will be cancelled. ⷠTo cancel the clock setting mode, press POWER to turn on the power, and press POWER again to turn off. If the sound is distorted, turn MEGABASS to OFF. The channel step of this unit is factory-set to 9 kHz or 10 kHz. Change the settings as shown below to be able to listen to the radio. Area North and South America Other countries/regions Channel step 10 kHz 9 kHz Should any problem persist after you have made the following checks, consult your nearest Sony dealer. The unit is being used in extremely high or low temperatures or in a place with excessive moisture. Very weak or interrupted sound, or unsatisfactory reception. In a vehicle or in a building, listen near a window. The station cannot be received when PRESET + or ­ is pressed. While holding down ENTER/CLOCK, keep pressing POWER for more than 5 seconds. [. . . ] caring for others Keep the volume at a moderate level. This will allow you to hear outside sounds and to be considerate to people around you. Quartz-controlled PLL (Phase Locked Loop) synthesizer system using a microcomputer for easy pinpoint tuning. [. . . ]