User manual SONY SRF-M78

[. . . ] ⷠIn vehicles or buildings, radio reception may be difficult or noisy. Do not use headphones while driving, cycling, or operating any motorized vehicle. It may create a traffic hazard and is illegal in many areas. [. . . ] When the batteries become weak, the sound becomes weak or distorted. When the batteries are completely exhausted, the power is turned off and " " in the display flashes. When the power is turned on with the indication flashing, the power will be turned off right away. When " " starts flashing, replace both batteries with new ones. ⷠReplace the batteries within about 40 seconds after removing the batteries. If you do not replace them within 40 seconds, the preset stations may be erased, the clock setting may be cleared and "0:00" or "AM 12:00" flashes in the display. ⷠWhen the batteries are removed for a long time, preset stations will be erased and "0:00" or "AM 12:00" is displayed. The Channel step of this unit is factory-set to 10 kHz (models for North and South America)/ 9 kHz (models for other countries). Area North and South American countries Other countries Channel step 10 kHz 9 kHz When the unit is not to be used for a long period of time, remove the batteries to avoid damage caused by battery leakage and corrosion. Stereo headphones (1, vertical-in-the-ear type) Arm band (1) Design and specifications are subject to change without notice. To release the key protection, press HOLD again. Set the clock when the radio is turned off. When you insert batteries for the first time, digits flash in the display. While holding down ENTER/CLOCK, press either TUNE/TIME SET + or ­ till the correct time appears in the display. [. . . ] Move the velcro fastener to the proper position. Remove the rubber belt from the unit and clean them. The straightened band will wind easily when you touch or wiggle it. [. . . ]