User manual SONY SRF-M80V

[. . . ] 3-239-332-22(1) Notes on Headphones Road safety Installing the Batteries (See Fig. A­ ) 1 Open the battery compartment lid and install two size AAA (R03) batteries (not supplied) with correct polarity. When batteries are first installed, "AM 12:00" flashes in the display. Once the current time is set, the flashing stops. TV/WEATHER/FM Stereo/AM PLL Synthesized Radio Operating Instructions Do not use headphones while driving, cycling, or operating any motorized vehicle. It may create a traffic hazard and is illegal in many areas. [. . . ] · Wearable round design for armband and belt-holder use. · Water-resistant for all ­weather use. · MEGA BASS for dynamic bass sound. Notes on AM Channel Step The AM channel step differs depending on areas. See "Changing AM Channel Step". Precautions · Operate the unit only on 3 V DC with two size AAA (R03) batteries. · Avoid exposure to temperature extremes, direct sunlight, moisture, sand, dust or mechanical shock. Never leave the unit in a car parked under the sun. · Should anything fall into the unit, remove the batteries and have the unit checked by qualified personnel before operating it any further. · To clean the casing, use a soft cloth dampened with a mild detergent solution. · In vehicles or buildings, radio reception may be difficult or noisy. Try listening near a window. Output i (headphones) jack (ø 3. 5 mm stereo minijack) 16 Power output 15 mW + 15 mW (at 10 % harmonic distortion) Power requirements 3 V DC, two size AAA (R03) batteries Dimensions Approx. 69. 2 × 45 × 113. 5 mm (w/h/d) (2 3/4 × 1 13/16 × 4 1/2 inches) incl. projecting parts and controls Mass Approx. batteries Accessories Supplied Stereo headphones (vertical in the ear type) (1) Arm band (1) Design and specifications are subject to change without notice. Using the Arm Band PRESET TUNING 1 to 5* MEGA BASS SPLIT/RESET (See Fig. B­ ) Press MODE to select a function mode. Each function mode can be selected as follows: Radio frequency* Clock Stopwatch 3 Press START/STOP to stop. 1 2 3 4 Slide the connector onto the unit until you hear a click. Unwind and straighten the wraparound arm band. To more easily straighten the band, slightly bend the tip of the band in the opposite direction. To reset to zero, press SPLIT/RESET when the stopwatch is in the stop status. The stopwatch comes with two display modes. To switch to the hourminute-second display, press ENTER. To switch to the minute-second-split second display, press ENTER again. Hold the body of the unit and attach the straightened band to your arm. The band will wind by itself. Tighten the band with the rubber belt. ) Countdown timer Pitch timer START/STOP To remove the arm band from the unit (See Fig. B­ * Selected only when the power is on. When the count time exceeds "59:59 99" during the minute-second-split second display, the display switches to the hour-minute-second display. To switch to the other modes during counting, press MODE. [. . . ] The channel step of this unit is factory-set to 10 kHz. Change the settings as shown below to be able to listen to the radio. Area North and South American countries Other countries Channel step 10kHz 9kHz Presetting a station 1 Follow steps 1 to 4 in "Playing the Radio" and manually tune 2 in to the station you wish to preset. Press the PRESET TUNING button you wish to preset for more than a few seconds. You will hear two confirmation beeps and preset number appears in the display. [. . . ]