User manual SONY SRF-S54

[. . . ] ­­ Increase the separation between the equipment and receiver. ­­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ­­ Consult the dealer or an experienced radio/TV technician for help. Dimensions: Approx. 105 x 68 x 38. 6 mm (w/h/d) (4 1/8 x 2 3/4 x 1 1/2 inches) excl. [. . . ] · The name plate indicating operating voltage, etc. · Avoid exposure to temperature extremes, direct sunlight, moisture, sand, dust, or mechanical shock. · Should anything fall into the unit, remove the batteries, and have the unit checked by qualified personnel before operating it any further. · To clean the casing, use a soft cloth dampened with a mild detergent solution. · In vehicles or buildings, radio reception may be difficult or noisy. Try listening near a window. Accessories supplied: Stereo headphones (1, vertical-in-the-ear type) Arm band (1) Design and specifications are subject to change without notice. Notes on Headphones Road safety Do not use headphones while driving, cycling, or operating any motorized vehicle. It may create a traffic hazard and is illegal in many areas. It can also be potentially dangerous to play your headphones at high volume while walking, especially at pedestrian crossings. You should exercise extreme caution or discontinue use in potentially hazardous situations. Preventing hearing damage Avoid using headphones at high volume. Hearing experts advise against continuous, loud and extended play. If you experience a ringing in your ears, reduce volume or discontinue use. Caring for others Keep the volume at a moderate level. When you release ENTER/ CLOCK, the clock begins to operate and ":" flashes. Tuning in a Preset Station Press POWER to turn the radio on. Select the desired band by pressing BAND. The preset number will appar in the display. 4 Adjust VOL (volume). 1 2 3 Using the Arm Band (See fig. B) 1 2 3 Hold both edges of the connector and slide the connector onto the unit until you hear a click Unwind and straighten the wraparound band. To more easily straighten the band, slightly bend the tip of the band in the opposite direction. Hold the body of the unit and attach the straightened band to your arm. Tighten the band with the rubber belt. A ] } ] } · Each press of TUNE/TIME SET + or ­ advances or returns the displayed time by one minute. · To set the current time rapidly, keep pressing TUNE/TIME SET + or ­ while holding down ENTER/CLOCK. Changing AM Channel Step The channel step of this unit is factory-set to 10 kHz to match the frequency allocation system of the country as listed. Area North and South American countries Other countries Channel step 10 kHz 9 kHz 4 To remove the arm band from the unit (See fig. C) Hold both edges of the connector and slide the connector. To vary the length of the rubber belt to fit your arm (See fig. [. . . ] D) Move the velcro fastener to the proper position. AAA (R03) x 2 B 1 2 If the rubber belt and wraparound band becomes dirty Change the AM channel step when the radio is turned off. While holding down ENTER/CLOCK, keep pressing POWER for more than 5 seconds. If you proceed step 2 again, the channel step changes again. Remove the rubber belt from the unit and clean them. 1 Caution (See fig. E) · Avoid bending the wraparound band forcibly in the opposite direction. [. . . ]