User manual SONY SRF-S84

[. . . ] The radio is automatically turned on when the radio is off. After the preset countdown duration, the four beeps sound five times and the radio is turned off. 2Press the PRESET TUNING button you wish to preset for more than a few seconds. You will hear two confirmation beeps and preset number appears in the display To preset another station, repeat these steps. [. . . ] Area North and South American countries Other countries Channel step 10kHz 9kHz You can check the remaining battery power that appears in the display. Holding down the desired PRESET TUNING button for more than a few seconds will replace the previous station on the PRESET TUNING button with the station you tuned in to. When the battery becomes exhausted, the unit will turn off. When you press POWER after installing the new batteries, the indicator ". When the AM channel step is changed, the preset stations for AM will be initialized. The stopwatch can time up to 99 hours 59 minutes and 59. 2Press MODE repeatedly to select the clock mode when the clock mode is not on. 3While holding down TUNE/ TIME SET + or ­, keep pressing MODE for more than 5 seconds. Two short beeps sound, and the AM channel step will be changed. "AM 9" (or "AM 10") is displayed for about 2 seconds. If you proceed to step 3 again, the channel step changes again. This unit is designed so that it can be used with slight exposure to rain, snow and other forms of moisture, but there are several points on which caution should be observed. ⷠDo not allow it to come in contact with large amounts of water. If water should get on it or if it should fall into water, take it out immediately and wipe it off with a dry cloth. the interior of the battery compartment has no splash-resistance. The battery may corrode, so wipe out the interior of the battery compartment as follows. ­ Open or close the battery compartment with dry hands in a place without exposure to any water. ­ Wipe off the battery and the inside of the battery compartment. The battery compartment lid is designed to come off when opened with excessive force. To put it back on, see the illustration. To display the current split time, press SPLIT/RESET while the stopwatch is running. "SPLIT" flashes in the display. [. . . ] The unit is being used in extremely high or low temperatures or in a place with excessive moisture. Move the velcro fastener to the proper position. Remove the rubber belt from the unit and clean them. " Two short beeps sound when the minimum frequency of each band is received during tuning. [. . . ]