User manual SONY SRF-F1

[. . . ] Once the current time is set, the flashing stops. FM Stereo PLL Synthesized Headphone Radio Operating Instructions "WALKMAN" is a registered trademark of Sony Corporation to represent Headphone Stereo products. is a registered trademark of Sony Corporation. FM WALKMAN Printed on 100% recycled paper using VOC (Volatile Organic Compound)free vegetable oil based ink. Printed in China Notes on battery · Do not attempt to charge a dry battery. [. . . ] When you set POWER to ON after installing the ". new battery, the indicator changes to " * Displayed only when the radio is turned on. Note Do not take more than 30 seconds to replace the battery, otherwise, your clock and preset stations will be initialized. Should this happen, reset the functions again. WARNING You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. This device complies with the Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. Features · · · · PLL (phase locked loop) synthesized tuning radio. Water-resistant for all ­weather use. 15 stations can be preset. Power output 4 mW + 4 mW (at 10 % harmonic distortion) Headphone type Closed, dynamic Power requirements 1. 5 V DC, one size AAA (R03) battery Mass Approx. battery Supplied accessories Earbuds (S × 2, L × 2) Design and specifications are subject to change without notice. Precautions · Operate the unit only on 1. 5 V DC with one size AAA (R03) battery. · Avoid exposure to temperature extremes, direct sunlight, moisture, sand, dust or mechanical shock. Never leave the unit in a car parked under the sun. · Should anything fall into the unit, remove the battery and have the unit checked by qualified personnel before operating any further. Hold down MEGA BASS/CLOCK for more than 2 seconds. A beep sounds and the hour flashes in the display. AM Presetting Your Favorite Station -- Preset Tuning You can preset up to 15 FM stations. You can also delete a preset station, whether it is factory-set or preset by yourself. Presetting a Station 1 Follow steps 1 to 3 in "Playing the Radio" and manually tune in to 2 the station you wish to preset. Hold down MODE/ENTER until the preset number flashes. A preset number without a preset station will flash. When all the preset numbers are set to stations, the following occurs: · Initialized (factory-set): "1" flashes and "P" appears. · After tuning in a preset station: The next preset number after the one last preset flashes and "P" appears. Neckband 3 4 Press TUNE + or ­ until the correct hour appears in the display. Each press changes the digit(s) by one. When you keep the button pressed, the digit(s) change rapidly. Press MEGA BASS/CLOCK. A beep sounds and the minutes start to flash. After setting, press MEGA BASS/CLOCK again. Two beeps sound, ":" starts flashing, and the clock starts from 0 seconds. If you press MODE/ENTER while setting, the clock, the clock setting will be canceled. AM Driver unit Driver unit MODE/ENTER VOL ­ VOL +* P MEGA BASS/ CLOCK 3 Press TUNE + or ­ to select the number you wish to preset, then press MODE/ENTER. When you select the preset number using TUNE + or ­, "P" appears if that number has a preset station. If it has no preset station, only the number flashes and "P" does not appear. When you press MODE/ENTER, the selected preset number lights up in the display. [. . . ] 2 Press MODE/ENTER so that "P" and preset number appear. 3 Press TUNE + or ­ to select the desired preset number. 4 Adjust the volume using VOL + or ­. To turn off the radio, set POWER to OFF. C -- Manual Tuning 1 Set POWER to ON (DX) to turn on the power. 2 If "P" is displayed, press MODE/ENTER so that "P" disappears. Pressing MODE/ENTER will switch over between manual tuning mode and preset tuning mode. Deleting a Preset Station 1 Follow steps 1 and 2 in "Tuning in to a Preset Station". [. . . ]