User manual SONY SRF-M35

[. . . ] If you experience a ringing in your ears, reduce volume or discontinue use. INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] (North and South American model) The FM channel step is set to 0. 05 MHz* and the AM channel step is set to 9 kHz. (Other models) When to replace the batteries · When the batteries become weak, the sound becomes weak or distorted. When the batteries are completely exhausted, the power is turned " in the display window off and " flashes. When the power is turned on with the indication flashing, the power will be turned off right away. " starts flashing, replace both When " batteries with new ones. · Replace the batteries within about 40 seconds after removing the batteries. If you do not replace them within 40 seconds, the preset stations may be erased, the clock setting may be cleared and "AM 12:00" flashes in the display. · When the batteries are removed for a long time, preset stations will be erased and "AM 12:00" will flash in the display. Store stations and set the clock again. * The FM frequency display is raised or lowered by a step of 0. 1 MHz. For example, frequency 88. 00 and 88. 05 MHz is displayed as "88. 0 MHz. " Two short beeps sound when the minimum frequency of each band is received during tunig. 5 Adjust the volume using VOL. Notes on batteries · Do not charge the dry batteries. · Do not carry the dry batteries with coins or other metallic objects. It can generate heat if the positive and negative terminals of the batteries are accidentally contacted by a metallic object. · When you are not going to use the unit for a long time, remove the batteries to avoid damage from battery leakage and corrosion. · Do not use different types of batteries at the same time. [. . . ] The new station will replace the previous station on the preset button. Changing AM Channel Step The AM channel step differs depending on areas. The channel step of this unit is factory-set to 10 kHz to match the frequency allocation system of the country as listed. Area North and South American countries Other countries Channel step 10 kHz 9 kHz 1 2 3 4 Tuning in a preset station Press POWER to turn the radio on. [. . . ]