User manual SONY SRF-M85V

[. . . ] 2-585-437-21(1) Warning If there is lightning when you are using the unit, take off the headphones immediately. Installing the Battery (See Fig. A­ ) 1 Open the battery compartment lid and install one size AAA (R03) battery (not supplied) with correct polarity. When a battery is first installed, "AM 12:00" flashes in the display. Once the current time is set, the flashing stops. TV/WEATHER/FM Stereo/AM PLL Synthesized Radio Operating Instructions "WALKMAN" is a registered trademark of Sony Corporation to represent Headphone Stereo products. is a registered trademark of Sony Corporation. [. . . ] It may create a traffic hazard and is illegal in many areas. It can also be potentially dangerous to play your headphones at high volume while walking, especially at pedestrian crossings. You should exercise extreme caution or discontinue use in potentially hazardous situations. Preventing hearing damage Avoid using headphones at high volume. Hearing experts advise against continuous, loud and extended play. If you experience a ringing in your ears, reduce volume or discontinue use. Caring for others Keep the volume at a moderate level. This will allow you to hear outside sounds and to be considerate to people around you. MB RADIO ON STPW PITCH TV WEATHER SPLIT TIMER FM AM PM Using the Arm Band (See Fig. B­ ) 1 Slide the connector onto the unit until you hear a click. 2 Unwind and straighten the wraparound arm band. HOLD lever To more easily straighten the band, slightly bend the tip of the band in the opposite direction. Selecting the Mode You can use this unit as a radio, clock, stopwatch, pitch timer or countdown timer. The functions of clock, stopwatch, pitch timer, countdown timer are available even if the power is off. Press DISPLAY to select a function mode. Each function mode can be selected as follows: Radio frequency* Clock Stopwatch 3 Press TUNE/TIME SET + or ­ to select the number you wish to preset, then press ENTER. When you select the preset number using TUNE/TIME SET + or ­, "P" appears if that number has a preset station. If it has no preset station, only the number flashes and "P" does not appear. When you press ENTER, the selected preset number lights up in the display. Example: Display window when you preset FM 90. 0 MHz in preset number 2. Using the Pitch Timer The pitch timer allows setting the timer with an identical length of time repeatedly. The functions of the radio, the stopwatch, and the countdown timer are available even while the pitch timer is being used. i (headphones) jack POWER START/STOP SPLIT/RESET MEGA BASS ENTER MODE TUNE/TIME SET +/­*1 *1The TUNE/TIME SET + has a tactile dot. VOL* 2 1 2 Press DISPLAY to select the pitch timer. "PITCH" flashes in the display. 3 4 Hold the body of the unit and attach the straightened band to your arm. The band will wind by itself. Hold down ENTER for more than 2 seconds. The beep sounds and the countdown duration flashes in the display. Tighten the band with the rubber belt. BAND DISPLAY To remove the arm band from the unit (See Fig. B­ ) While holding down "PUSH RELEASE" (1), slide the connector to remove the arm band (2). The arm band can be attached either on left or right arm by changing up side down. The unit can also be removed with the arm band attached on your arm, as instructed above. Countdown timer Pitch timer To preset another station, repeat these steps. To change the preset station, preset a new station. [. . . ] "TIMER" stops flashing if changed to other mode while the countdown timer counts down. Notes · One you start setting the clock, you must perform each step within 65 seconds, or the clock setting mode will be cancelled. · 12-hour system: "AM 12:00" = midnight, "PM 12:00" = noon. Press START/STOP to start. The display shows the elapsed time. Press START/STOP to stop. To reset to zero, press SPLIT/RESET when the stopwatch is in the stop status. The stopwatch comes with two display modes. To switch to the hour-minutesecond display, press ENTER. [. . . ]