User manual SONY SRF-S80

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ­ Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ­ Consult the dealer or an experienced radio/ TV technician for help. Caring for others Keep the volume at a moderate level. [. . . ] If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. Specifications Time display: 12-hour system Frequency range: Band: FM: AM: FM: AM: Frequency 87. 5 - 108 MHz 530 - 1 710 kHz 87. 5 - 108 MHz 531 - 1 710 kHz Channel step 0. 1 MHz 10 kHz 0. 05 MHz 9 kHz Output: Before You Begin Thank you for choosing the Sony radio!It will give you many hours of reliable service and listening pleasure. Before operating the radio, please read these instructions throughly and retain them for future reference. i jack (ø 3. 5 mm stereo minijack) Power output 18 mW + 18 mW (at 10 % harmonic distortion) Power requirements 3V DC, two size AAA (R03) batteries Dimensions: Approx. 82 × 72 × 32 mm (w/h/d) (3 1/4 × 2 7/8 × 1 5/16 inches) incl. batteries and the belt holder Mass: Features · FM stereo /AM PLL (Phase Locked Loop) Synthesized radio · Up to 15 stations (10 for FM, 5 for AM) can be preset for one-touch tuning Accessories supplied: Stereo headphones (1) Belt holder (1) Design and specifications are subject to change without notice. Notes on AM channel step The AM channel step differs depending on the areas. The channel step of this unit is factory-set to 10 kHz. Area North and South American countries Other countries Channel step 10 kHz 9 kHz Installing the Batteries (See Fig. A) 1 2 3 VOL Slide and open the lid at the rear of the radio. Insert two size AAA(R03) batteries (not supplied) with correct polarity. Close the lid. Playing the radio Manual Tuning 1 2 3 Connect the supplied headphones to the i (headphones) jack. · To turn off the radio, press POWER. · To improve the radio reception FM: Extend the headphones cord so that the FM sensitivity will be increased, as it serves as the FM antenna. AM: Rotate the unit horizontally for optimum reception. A ferrite bar antenna is built into the unit. · For FM, set FM SENS to LOCAL if interference is prevalent and reception is too strong. Under normal conditions, set it to DX. A Size AAA (R03) × 2 B1 2 Insert the # side of the battery first. To attach the battery compartment lid if it is accidentally detached (see Fig. B) 1 Put in one side of the lid as illustrated. 2 Push the other side to attach. Preset Tuning You can preset 10 stations in FM (5 stations in FM1, 5 stations in FM2) and 5 stations in AM. Presetting a station Example: To set FM 90 MHz in Preset button 2 for FM2 Setting the Clock The display will flash "AM 12:00" when the batteries are first inserted. 1 Using the Belt Holder Hold down CLOCK for more than 2 seconds. The hour flashes in the display. 1 2 3 4 Press POWER to turn the radio on. Tune in to FM 90 MHz (See "Manual Tuning"). Hold down PRESET button 2 for more than 2 seconds. Two beeps sound and the preset number "2" appears in the display. 2 Press TUNE/TIME SET + or ­ until the correct hour appears in the display. To set the current time rapidly, hold down TUNE/TIME SET + or ­. 3 Press CLOCK. The minutes starts to flash. To detach To attach Repeat step 2 and 3 to set the minute. [. . . ] Hold down PRESET button 2 for more than 2 seconds. Two beeps sound and the preset number "2" appears in the display. 2 Press TUNE/TIME SET + or ­ until the correct hour appears in the display. To set the current time rapidly, hold down TUNE/TIME SET + or ­. 3 Press CLOCK. The minutes starts to flash. To detach To attach Repeat step 2 and 3 to set the minute. After setting the minute, press CLOCK again. The clock starts operating and " : " starts flashing. · 12-hour system: "AM 12:00" = midnight "PM 12:00" = noon To preset another station, repeat these steps. [. . . ]