User manual SONY SRS-D511

[. . . ] Slide the stand into the slot at the bottom of the satellite speaker. Push the stand into the slot until a "click" sound is heard. You cannot use the BASS, REAR or CENTER volume dial. Do not put your finger into the slot of the satellite speaker when you lock the stand. [. . . ] Apply a bond (anaerobic threadlocking material) to the hollow wall anchor to prevent the screw loosening. There is hum or noise in the speaker output. Make sure none of the audio components are positioned too close to the TV set. Satellite speaker with 2-meter cord (2) with 3-meter cord (3) Enceinte satellite avec cordon de 2 mètres (2) avec cordon de 3 mètres (3) Before operating the system, be sure that the operating voltage of the system is identical with that of your local power supply. The brightness of the OPERATE indicator may become unstable when the volume is turned up. 7 cm, cone type Closed type 4 2 m (for front L and front R speakers) 3 m (for rear L, rear R and center speakers) Woofer 12 cm, cone type Bass reflex 8 5 W (10% T. Detach the stand from the satellite speaker before attaching to the wall. Anchor hole Orifice d'ancrage Hollow wall anchor (ø 4 mm, not supplied) Dispositif d'ancrage pour mur creux (ø 4 mm, non fourni) The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. Unplug the system from the wall outlet if it is not to be used for an extended period of time. Should any liquid or solid object fall into the system, unplug the system's power cord and have the system checked by qualified personnel before operating it any further. The AC power cord should be changed only at a qualified service shop. For efficient heat dissipation, ensure there is sufficient space to the rear of the subwoofer. Do not insert your hand or any objects into the hole of the subwoofer. ­ Line out of sound card or sound box: Connect the INPUT 1 jacks (FRONT, REAR, and CENTER/SUBWOOFER) of the controller and the jacks of the sound card with the supplied connecting cable. The connecting cord is not supplied with this system. Do not drive the speaker system with a continuous wattage exceeding the maximum input power of the system. Before connecting, turn off the speaker system, the PC and audio component to avoid damaging the speaker system. The volume level should not be turned up to the point of distortion. [. . . ] The volume should be set to minimum before you begin playing the programme source. Design and specifications are subject to change without notice. Do not leave the system in a location near heat sources, or in a place subject to direct sunlight, excessive dust, moisture, rain or mechanical shock. Do not install the satellite speaker anywhere other than on a wall. [. . . ]