User manual SONY SRS-NWZ10

[. . . ] To reduce the risk of fire or electric shock, do not place objects filled with liquids, such as vases, on the apparatus. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Connect the AC power adaptor to an easily accessible AC outlet. Should you notice an abnormality in the AC power adaptor, disconnect it from the AC outlet immediately. [. . . ] The battery cannot be inserted, or fits too tightly in the Card Remote Commander. The battery is designed so as not be inserted in the wrong direction. Card Remote Commander operation is not possible. Operate the card remote commander pointed toward the remote sensor of the cradle. Remove any obstacle between the cradle and the card remote commander. If the above remedies do not solve the problem, the battery might be worn out. Replace the lithium battery CR2025 with a new one, with the + side facing up. After operating the system with the AC power adaptor, disconnect the AC power adaptor from the wall outlet if the system is not to be used for an extended period of time. Just switching the |/1 button to standby does not turn the AC power adaptor off. Keep the lithium battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor. Wipe the battery with a dry cloth to assure a good contact. Be sure to install the battery with the correct polarity. Do not hold the battery with metallic tweezers as doing so may cause a short-circuit. Use of other batteries than the CR2025 may cause a risk of fire or explosion. Do not leave the system in a location near heat sources, or in a place subject to direct sunlight, excessive dust, moisture, rain or mechanical shock. Impedance Rated input power Maximum input power Should any solid object or liquid fall into the system, have the system checked by qualified personnel before operating it any further. Although this system is magnetically shielded, do not leave recorded tapes, watches, personal credit cards, or floppy disks with magnetic coding in front of the system for an extended period of time. Listening to the sound 1 Disconnect the USB cable used for the unit and personal computer, or set the POWER switch of the connected personal computer to OFF. When a USB cable is connected between the unit and a personal computer, no sound will be heard from a Walkman set on the WM-PORT connector. Depending on the computer you are using, setting the power switch to off may not release data transfer mode. Sound from the device connected to INPUT jack will be heard instead. [. . . ] Insert your Walkman fully into the cradle. Playback and recharging can be done at the same time. Charging time varies depending on use of the AC power adaptor or USB cable. Before connecting or disconnecting the AC power adaptor, turn off the system. [. . . ]