User manual SONY SRS-Z100

[. . . ] Plug the AC power adaptor into a nearby AC output. in the case of a problem , unplug from the AC outlet immediately. Do not place the AC power adaptor on a bookshelf or in a confined place, such as a cabinet. To avoid fire or electric shock do not use the AC power adaptor in a place subject to liquid or moisture. [. . . ] There is hum or noise in the speaker output. Make sure no audio devices are positioned too close to the TV set. Press down near the projection of the cover on the rear of the left speaker to open. Pass the cord of the AC power adaptor through the slit of the cover. The system will not turn on automatically when the Auto Power On/Off function is on When connected to the headphones jack, turn up the volume of the source device. The system will not turn off automatically when the Auto Power On/Off function is on You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. The validity of the CE marking is restricted to only those countries where it is legally enforced, mainly in the countries EEA (European Economic Area). Move the source device away from the system. Move the system away from devices that generate strong microwaves, such as mobile phones. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Although this system is magnetically shielded, do not leave recorded tapes, watches, personal credit cards, or floppy disks with magnetic coding in front of the system for an extended period of time. If no signal is input for about 90 seconds or more*, the system turns off automatically. * This may vary according to how the speaker is used. Notes If the input signal level is too low, the system will not turn on automatically. If a device that generates microwaves, such as a mobile phone, is nearby, the system may be turned on unintentionally by the device. If a mobile phone is connected to the system, the system may be turned on unintentionally by noise or an incoming call. When connecting a mobile phone, turn on/off the system manually by the POWER switch. The system may not turn off automatically because of received noise, depending on the source device. If no device is connected, the system may not turn off automatically, or it may turn on unintentionally. The beginning of the input signal may not be heard, depending on the input signal level. Do not leave the system in a location near heat sources, or in a place subject to direct sunlight, excessive dust, moisture, rain or mechanical shock. [. . . ] Do not leave the system in a location near heat sources, or in a place subject to direct sunlight, excessive dust, moisture, rain or mechanical shock. Do not use alcohol, benzine or thinner to clean the cabinet. Although this system is magnetically shielded, there may be cases that the picture on some TV sets/personal computers may become magnetically distorted. In such a case, turn off the power of the TV set/personal computer once, and after 15 to 30 minutes turn it on again. [. . . ]