User manual SONY SRS180

[. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. the recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. [. . . ] Before operating the system, be sure that the operating voltage of the system is identical with that of your local power supply. Use only the supplied AC power adaptor . After operating the system with the AC power adaptor, disconnect the AC power adaptor from the wall outlet if the system is not to be used for an extended period of time. The POWER switch does not turn the AC power adaptor off. Do not leave the system in a location near heat sources, or in a place subject to direct sunlight, excessive dust, moisture, rain or mechanical shock. Do not use alcohol, benzine, or thinner to clean the cabinet. Should any solid object or liquid fall into the system, have the system checked by qualified personnel before operating it any further. Although this system is magnetically shielded, do not leave recorded tapes, watches, personal credit cards, or floppy disks with magnetic coding in front of the system for an extended period of time. If the input signal level is too low, the system will not turn on automatically. If a device that generates microwaves, such as a mobile phone, is nearby, the system may be turned on unintentionally by the device. If a mobile phone is connected to the system, the system may be turned on unintentionally by noise or an incoming call. When connected to the headphones jack, turn up the volume of the source device. Stand cover holes Orifices pour le fourreau du support Bohrungen für Ständerabdeckung Orificios de la cubierta del soporte Stand cover Fourreau du support Ständerabdeckung Cubierta del soporte The system will not turn off automatically when the Auto Power On/Off function is on. Move the source device away from the system. Move the system away from devices that generate strong microwaves, such as mobile phones. Note on the AC power adaptor Use only the supplied AC power adaptor. Do not use any other AC power adaptor to avoid damaging the speakers. Speaker system Enclosure type Impedance Rated input power Maximum input power 48 mm, Full range, magnetically shielded Bass reflex 4 1. Attach the stand cover to the stand cover hole securely until it locks into position. Insert the stand into the stand holder, and push into the stand cover fully to secure it. Insérez le support dans son dispositif de maintien et poussez complètement le fourreau du support pour le bloquer. When the system is connected to the monaural jack of the source device The sound may not come through the right side. [. . . ] notes · Because light, such as direct sunlight, is refracted when it passes through the stand, and may focus in one place (as it would by a lens), it may cause a fire to occur at the focused point. Please keep the stand in a place not subject to a source of light when unattended. If you operate a portable player with the player installed on the stand, this unit may fall backwards. Be sure to operate the portable player by holding it on your hand. [. . . ]