User manual SONY SRS38

[. . . ] Recording is not possible while this unit is in standby mode. To remove the attachment, push at the position marked (a a a) on the attachment as shown in illustration (Removing 1), or as shown in illustration (Removing 2), while holding the Walkman installing portion of the attachment pushed towards the rear side of the cradle, press downwards at the position marked (a a a). z Tips · This unit can be used with a Walkman that meets the following requirements. WM-PORT* (22 pin) compatible ­ Supplied circular attachment · The shape of the attachment may vary according to your Walkman. [. . . ] Insert your Walkman fully into the cradle. There is hum or noise in the speaker output. Make sure none of the audio components are positioned too close to a TV set. (rear) (arrière) AC power adaptor (supplied) Adaptateur secteur (fourni) to wall outlet Vers une prise murale Card remote commander (rear) Mini-télécommande (arrière) Card remote commander (rear) Mini-télécommande (arrière) The following URLs contain information on the latest customer support for the speaker, and frequently asked questions and answers. Preparing the card remote commander (See fig. g) Before using the card remote commander for the first time, remove the insulation film. The battery is installed in the card remote commander at the factory. The brightness of the |/1 indicator may become unstable when the volume is turned up. Before operating the system, be sure that the operating voltage of the system is identical with that of your local power supply. The working distance of the card remote commander shortens as the battery becomes exhausted. Replace the battery with a new one following the procedure below. Power Dimensions (w/h/d) DC 12 V (supplied AC power adaptor) Approx. Do not use alcohol, benzine, or thinner to clean the cabinet. If you have any questions or problems concerning your speaker system, please consult your nearest Sony dealer. Although this system is magnetically shielded, there may be cases that the picture on some TV sets/personal computer sets may become magnetically distorted. In such a case, turn off the power of the TV set/personal computer set once, and after 15 to 30 minutes turn it on again. For the personal computer set, take the appropriate measures such as data storage before turning it off. When there seems to be no improvement, locate the system further away from the TV set/personal computer set. Furthermore, be sure not to place objects in which magnets are attached or used near the TV set/personal computer set, such as audio racks, TV stands, toys etc. These may cause magnetic distortion to the picture due to their interaction with the system. AC power adaptor (1) Mains lead (1) Card Remote Commander (1) Lithium battery CR2025 (1) (preinstalled for the trial use) Operating Instructions (1) Warranty (1) The Walkman attached to the WM-PORT connector on this unit can be controlled by the supplied card remote commander. Set the volume of the source device to moderate level, and press the VOL +/­ buttons on this unit. [. . . ] Note Some operations of the card remote commander may not work, or work differently as indicated, depending on the specification of the Walkman you are using. A Walkman set on the WM-PORT connector can be recharged by either the AC power adaptor (supplied), or by using a USB cable (supplied with the Walkman) connected to a computer. Using on house current Use only the supplied AC power adaptor. Do not use any other AC power adaptor to avoid damaging the speaker. [. . . ]