User manual SONY SRSD2100

[. . . ] 3-264-412-11(1) C PC, CD or MD Walkman, etc. Installing the satellite speakers (See fig. A) Use the supplied screws to attach the base to the satellite speaker. The satellite speaker can be used either placed on a desk or attached to a wall. Troubleshooting Should you encounter a problem with your speaker system, check the following list and take the indicated measures. If the problem persists, consult your nearest Sony dealer. Active Speaker System Operating Instructions Manual de instrucciones There is no sound from the speaker system. · Make sure all the connections have been correctly made. [. . . ] For details, refer to the operating instructions of the PC. ­ CD/MD Walkman, etc. : Connect the INPUT2 jack of the control box and the LINE OUT or headphones jack of a CD/MD Walkman, etc. The connecting cord is not supplied with this system. Design and specifications are subject to change without notice. Note First, be sure to apply a bond (anaerobic threadlocking material) to the hollow wall anchor to prevent the screw loosening. , This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. 5 mm 7 mm ø 4 mm On cleaning Do not use alcohol, benzene, or thinner to clean the cabinet. If you have any questions or problems concerning your speaker system, please consult your nearest Sony dealer. Note To switch INPUT1 and INPUT2, use ON/OFF of the device connected to the control box. 4 5 Note 9. 5 mm or more Do not hang on the satellite speaker or hang anything on it. Connect the subwoofer to the wall outlet. C) Precautions On safety The nameplate indicating operating voltage, power consumption, etc. , is located on the rear exterior. · Before operating the system, be sure that the operating voltage of the system is identical with that of your local power supply. B Connecting cord (not supplied) to INPUT2 jack Control Box (rear) to 8-pin Din jack Connecting Cable (supplied) to LINE OUT or headphones jack Satellite speaker (rear) PC, etc. to INPUT1 jack to LINE OUT or headphones jack (stereo mini-jack) CD/MD Walkman*, etc Listening to the sound (See fig. D) First, turn down the volume on the control box. The volume should be set to minimum before you begin playing the programme source. Where purchased U. S. A. /Canada European countries Other countries Operating voltage 120 V AC, 60 Hz 220 ­ 230 V AC, 50 Hz · 110 ­ 120 V AC, 50/60 Hz · 220 ­ 230 V AC, 50 Hz 1 2 Set the POWER switch to ON on the control box. The POWER indicator lights up. to Front R jack Subwoofer (rear) to Front L jack * "WALKMAN" is a registered trademark of Sony Corporation to represent Headphone Stereo products. · The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. · Unplug the system from the wall outlet if it is not to be used for an extended period of time. To disconnect the cord, pull the cord by grasping the plug. · Should any liquid or solid object fall into the system, unplug the system's power cord and have the system checked by qualified personnel before operating it any further. · The AC power cord should be changed only at a qualified service shop. · For efficient heat dissipation, ensure there is sufficient space to the rear of the subwoofer. Also, avoid placing objects on the unit. · Do not insert your hand or any objects into the hole of the subwoofer. Adjust the VOLUME control on the control box. You can adjust the volume of the subwoofer and each satellite speaker. When connecting to the headphone output, also adjust the volume of the connected component. After listening, set the POWER switch to OFF. The POWER indicator goes off. 3 Using headphones/earphones. Connect headphones/earphones to the PHONES jack on the control box. Note Turn off the MEGA BASS or BASS BOOST (Walkman, etc. ) function as it may cause audible distortion. to wall outlet Contenido del paquete D POWER PHONES Reproducción del sonido (consulte la figura D) Cuadro de controles En primer lugar, disminuya el volumen del cuadro de controles. Para evitar descargas eléctricas, no abra la unidad. En caso de avería, solicite los servicios de personal cualificado solamente. [. . . ] · Precisa un anclaje de pared hueca de 4 mm de diámetro. · Separe la cabeza del anclaje de pared hueca 5 mm de la pared. · Coloque una fijación (material anaerobio que no se deshilache) en el anclaje de pared hueca para evitar que el tornillo se suelte. Especificaciones Sección de los altavoces Altavoz satélite Sistema de altavoces Altavoces Tipo de caja Impedancia Longitud del cable Sistema de altavoces Altavoces Tipo de caja Impedancia Gama completa, protegidos magnéticamente 5, 6 cm, tipo cónico Tipo cerrado 6 3m Altavoz potenciador de graves 16 cm, tipo cónico Reflector de graves 6 Altavoz potenciador de graves a la toma LINE OUT o a la toma de auriculares Sección de amplificador Salida nominal Funcionamiento PC, etc. · No haga funcionar el sistema de altavoces permanentemente con una potencia superior a la potencia máxima de entrada del sistema. · Antes de realizar la conexión, apague el sistema de altavoces, el PC y el componente de audio para evitar dañar el sistema de altavoces. [. . . ]