User manual SONY SS-CN195

[. . . ] And don't place lighted candles on the apparatus. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Don't throw away batteries with general house waste; dispose of them correctly as chemical waste. WARNING This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] CAL] a) SIDE/LO, SIDE/HI, BEHD/LO, BEHD/HI 0% dim, 40% dim, 70% dim A. CAL YES, A. CAL NO Auto calibration a) [AUTO CAL. ] For details, refer to the page in the parentheses. 30US Adjusting the level (LEVEL menu) You can use the LEVEL menu to adjust the balance and level of each speaker. These settings are applied to all sound fields. Select "1-LEVEL" in the amplifier menus. For details on adjusting the parameters, see "Navigating through menus" (page 28) and "Overview of the menus" (page 29). x D. RANGE (Dynamic range compressor) Lets you compress the dynamic range of the sound track. This may be useful when you want to watch movies at low volumes late at night. Dynamic range compression is possible with Dolby Digital sources only. OFF The dynamic range is not compressed. STD The dynamic range is compressed as intended by the recording engineer. MAX The dynamic range is compressed dramatically. Tip Dynamic range compressor lets you compress the dynamic range of the soundtrack based on the dynamic range information included in the Dolby Digital signal. AUTO Automatically switches the input mode between DTS, Dolby Digital or PCM. PCM PCM signals are given priority (to prevent interruption when playback starts). However, when other signals are input, there may be no sound depending on the format. AUTO" and the sound from the digital audio jacks (for CD, etc. ) is interrupted when playback starts, set to "DEC. PCM". x NAME IN (Naming preset stations) Lets you set the name of preset stations. For details, see "Naming preset stations" (page 46). continued 33US x DUAL (Digital broadcast language selection) Lets you select the language you want to listen to during digital broadcast. This feature only functions for Dolby Digital sources. · DUAL M/S (Main/Sub) Sound of the main language will be output through the front left speaker and sound of the sub language will be output through the front right speaker simultaneously. · DUAL M (Main) Sound of the main language will be output. · DUAL S (Sub) Sound of the sub language will be output. · DUAL M+S (Main + Sub) Mixed sound of both the main and sub languages will be output. Settings for the system (SYSTEM menu) You can use the SYSTEM menu to set the distance of the speakers connected to this system. [. . . ] · Point the remote at the remote sensor on the receiver. · Remove any obstacles in the path between the remote and the receiver. · Replace all the batteries in the remote with new ones, if they are weak. · Make sure you select the correct input on the remote. Error messages AM Ground wire (not supplied) To ground If there is a malfunction, the display shows a message. [. . . ]