User manual SONY SS-CS8

[. . . ] ), soft dome type (1) Super tweeter: 19 mm (3/4 in. ), soft dome type (1) Rated impedance 6?Maximum input power 145 W Sensitivity level 88 dB (2. 50, 000 Hz ?230 x 922 x 260 mm Precautions On safety ?? [. . . ] Therefore, if you use the speakers near CRT-based televisions, color shading occurs on the television screen. Use caution when placing the speaker on a specially treated (waxed, oiled, polished, etc. ), soft dome type (1) Rated impedance 6?Maximum input power 145 W Sensitivity level 86 dB (2. ), including front grille Supplied accessory Foot pads (4) Design and specifications are subject to change without notice. 25, 000 Hz ?430 x 146 x 220 mm On cleaning Clean the speaker cabinets with a soft cloth lightly moistened with a mild detergent solution or water. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. If you have any questions or problems concerning your speaker system, please consult your nearest Sony dealer. Connecting the speakers to an amplifier Connect the speakers to the speaker output terminals of an amplifier using the speaker cords (not supplied). Make sure power to all components (included the subwoofer) is turned off before starting the hook up. When connecting, tighten the speaker terminals by turning them in the direction of the arrows in the illustration ?-?. ????????????????????? ????????? ?????????????????????????????Make sure the plus (+) and the minus (?) terminals on the speakers are matched to the corresponding plus (+) and minus (?) terminals on the amplifier. Be sure to tighten the screws of the speaker terminals securely as loose screws may become a source of noise. Contact between bare speaker wires at the speaker terminals may cause a short-circuit. For details on speaker connection of the amplifier, refer to the operating instructions supplied with your amplifier. (Left) Tip Black striped wires are minus (?) in polarity, and should be connected to the minus (?) speaker terminals. Positioning the speakers Install the speakers as shown in illustration ?-?. * SS-CS3 (Floor standing speaker) and SS-CS5  (Bookshelf speaker) can be used as either a front or a surround speaker. Tip Attach the foot pads (supplied) to the bottom corners of the speakers (see fig. [. . . ] N de modle N de srie Spcifications SS-CS3 (Haut-parleur de sol) Systme d?enceintes Systme d?enceintes 3 voies, 4 transducteurs, Bass reflex Haut-parleurs Haut-parleur de graves : 130 mm (5 1/4 po), type conique (2) Haut-parleur d?aigus : 25 mm (1 po), type en dme souple (1) Super haut-parleur d?aigus : 19 mm (3/4 po), type en dme souple (1) Impdance nominale 6?Puissance d?entre maximum 145 W Niveau de sensibilit 88 dB (2, 83 V, 1 m) Plage de frquences 45 Hz - 50 000 Hz Dimensions (largeur/hauteur/profondeur) Env. SS-CS5 (Haut-parleur de tablette) Systme d?enceintes Systme d?enceintes 3 voies, 3 transducteurs, Bass reflex Haut-parleurs Haut-parleur de graves : 130 mm (5 1/4 po), type conique (1) Haut-parleur d?aigus : 25 mm (1 po), type en dme souple (1) Super haut-parleur d?aigus : 19 mm (3/4 po), type en dme souple (1) Impdance nominale 6?Puissance d?entre maximum 100W Niveau de sensibilit 87 dB (2, 83 V, 1 m) Plage de frquences 53 Hz - 50 000 Hz Dimensions (largeur/hauteur/profondeur) Env. [. . . ]