User manual SONY SS-FCRW105

[. . . ] By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. the recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. Make sure power to all components (included the sub woofer) is turned off before starting the hook-up. [. . . ] Make sure power to all components (included the sub woofer) is turned off before starting the hook-up. Should you encounter a problem with your speaker system, check the following list and take the indicated measures. Make sure the plus (+) and the minus (­) terminals on the speakers are matched to the corresponding plus (+) and minus (­) terminals on the amplifier. ⷠBe sure to tighten the screws of the speaker terminals securely as loose screws may become a source of noise. ⷠMake sure all connections are firm. Contact between bare speaker wires at the speaker terminals may cause a shortcircuit. There is no sound from the speaker system. Make sure the volume on the amplifier has been turned up properly. ⷠMake sure the program source selector on the amplifier is set to the proper source. There is hum or noise in the speaker output. You are responsible for the proper selection and use of mounting hardware that you purchase at hardware stores, and for the proper and safe mounting of the speakers. The front and center speakers are magnetically shielded to allow it to be installed near a TV set. However, color irregularities may still be observed on certain types of TV sets. As the surround speakers are not magnetically shielded, we recommend that you place the surround speakers slightly further away from TV set. When connecting to an amplifier with internal multi channel decoders (Dolby Digital*1, DTS*2, etc. ), you should use the setup menus for the amplifier to specify the parameters of your speaker system. The setup menus for the amplifier differ depending on whether or not a sub woofer (not supplied) is used. See the table below for the proper settings. CTurn off the TV set, then turn it on again in 15 to 30 minutes. CPlace the speakers further away from the TV set. [. . . ] CTurn off the TV set, then turn it on again in 15 to 30 minutes. CPlace the speakers further away from the TV set. Speaker system Speaker unit Enclosure type Rated impedance Power handling capacity Sensitivity level Frequency range Dimensions (w/h/d) Mass Supplied accessory Do not place the speakers in locations that are: --Extremely hot or cold --Dusty or dirty --Very humid --Subject to vibrations --Subject to direct sunlight · Use caution when placing the speakers on a specially treated (waxed, oiled, polished, etc. ) floor, as staining or discoloration may result. [. . . ]