User manual SONY SS-RXD10AV

[. . . ] Please refer to the manual provided for SA-VE835ED, SA-VE535H, SAVE335 and SA-VE445H when you connect this speaker to the other speakers of SA-VE835ED, SA-VE535H, SAVE335 and SA-VE445H. Any difference in operation is clearly indicated in the text, for example, "SS-V831ED only". [. . . ] Attach the speaker to supplied speaker stand and place them at their optimum locations. Make sure the plus (+) and the minus (­) terminals on the speakers are matched to the corresponding plus (+) and minus (­) terminals on the amplifier. ⷠBe sure to tighten the screws of the speaker terminals securely as loose screws may become a source of noise. ⷠMake sure all connections are firm. Contact between bare speaker wires at the speaker terminals may cause a short-circuit. Pass the speaker cord into the hole on the back of the stand and out from the hole at the center of the stand. This speaker system is magnetically shielded to allow it to be installed near a TV set. However, color irregularities may still be observed on certain types of TV sets. C Turn off the TV set, then turn it on again after 15 to 30 minutes. C Place the speakers further away from the TV set. Do not place the speakers in locations that are: -- Extremely hot or cold -- Dusty or dirty -- Very humid -- Subject to vibrations -- Subject to direct sunlight · Use caution when placing the speaker on a specially treated (waxed, oiled, polished, etc. ) floor, as staining or discoloration may result. [. . . ] Clean the speaker cabinets with a soft cloth lightly moistened with a mild detergent solution or water. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. [. . . ]