User manual SONY SS-SP40FW

[. . . ] On transportation When you carry the display unit, hold the unit itself, not the speakers. If you fail to do so, the speakers may come out of the unit and the unit may fall. [. . . ] This speaker system is designed for use with the FWD series flat panel display. You can enjoy the high quality stereo sound. English Check the right and left speakers. Check the label indicating left ("L") or right ("R") on each speaker bracket. Attach the left ("L") speaker to the front left side and the right ("R") speaker to the front right side of the display. Follow the procedure below to attach the speakers: Pull the cable cover of the display to open. After checking the "L" or "R" label on each speaker bracket, align the display attachment holes 1 the speaker in brackets with the speaker attachment holes 2 the display, and fasten the in supplied attachment screws (b) (at two locations each in the left and right speakers). Caution Make sure that the screws are tightened. If they are not tightened enough, the speaker may fall and cause injury. Connect the speaker cords to the speaker terminals located at the bottom on the rear of the display, and to the speaker terminals on the middle of the speakers. [. . . ] Enclosure type 2 way Passive radiator type Rated impedance 6 ohms Power handling capacity Maximum input power: 7 W Characteristic sensitivity level 84 dB (1 W/1 m) Effective frequency range 100 Hz to 20, 000 Hz Operating conditions Temperature 0°C to 35°C (32°F to 95°F) Humidity 0 % to 90 % (no condensation) Pressure 700 hPa to 1, 060 hPa Transport and storage conditions Temperature ­10°C to +40°C (14°F to 104°F) Humidity 0 % to 90 % (no condensation) Pressure 700 hPa to 1, 060 hPa Dimensions SS-SP42FW Approx. Supplied accessories Speaker cord (2) Speaker attachment screw (4) Terminal cover (2) Operating instructions (1) Design and specifications are subject to change without notice. [. . . ]