User manual SONY SS-X70ED DATASHEET

[. . . ] Try this configuration instead of "Hookup A" in the following situations: -- When there are no jacks on the amplifier for a subwoofer. -- When you want stronger bass sound from the subwoofer. For details, see "Positioning the front (and rear) speakers" on page 7 and "Positioning the center speaker (SS-X70ED only)" on page 8. This configuration is used when the amplifier is connected to a CD player, MD deck, cassette deck, or other audio devices. [. . . ] â· Adjust the height of the front speakers so that it corresponds with the center of the TV screen, as illustrated below. Attach the front (and rear) speakers to supplied speaker stands and place them at their optimum locations. For details on the location of the front (and rear) speakers, see "Location of each speaker" on this page. Each speaker should face the listening position. Better surround effect will result if all speakers are set at the same distance from the listening position. Place the front speakers at a suitable distance to the left and right of the television. The rear speakers may be placed on both sides of the listening position A or behind the listening position B. Pass the speaker cord into the hole on the back of the stand and out from the hole at the center of the stand. Separate the speaker cord, then secure the cord to the speaker stand with the plate. For optimum listening enjoyment, the speaker should face directly towards the listener. The cord should be pressed into the groove in the stand. â· To increase the bass sound from the subwoofer, connect the system using "Hookup B" (see page 5). When "Hookup B" is used (Speaker setup menu) Before operating the system, be sure that the operating voltage of the system is identical with that of your local power supply. â· The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. â· Unplug the system from the wall outlet if it is not to be used for an extended period of time. Should any liquid or solid object fall into the system, unplug the system's power cord and have the system checked by qualified personnel before operating it any further. â· AC power cord must be changed only at the qualified service shop. If you encounter color irregularity on a near by TV screen This speaker system is magnetically shielded to allow it to be installed near a TV set. However, color irregularities may still be observed on certain types of TV sets. C Turn off the TV set once, then turn it on again after 15 to 30 minutes. C Place the speakers further away from the TV set. C Keep magnets and other sources of magnetic fields away from the speaker system since they may cause color irregularities on your TV screen. [. . . ] Should you encounter a problem with your speaker system, check the following list and take the indicated measures. if the problem persist , consult your nearest Sony dealer. There is no sound from the speaker system. Make sure the volume on the amplifier has been turned up properly. [. . . ]