User manual SONY SS-XB800AV

[. . . ] Before connecting, turn off the amplifier to avoid damaging the speaker system. If the +/­ connection is incorrect, the bass tones seem to be missing and the position of the instruments becomes obscure. In the event of any problems with the operation of the unit, contact your Sony service representative. Clean the cabinet with a soft, dry cloth. [. . . ] Clean the cabinet with a soft, dry cloth. If it is very dirty, use a cloth dampened with a small quantity of neutral detergent, then wipe dry. They may damage the surface finish, or impair the operation of the shutter adaptor. This may cause the internal temperature to rise excessively and the unit to malfunction. Wall attachment hole Speaker attachment holes Angle lock screw Attach the brackets to the speakers with the supplied M5 screws (black, 3 screws each for left and right holes). ) Loosen the panel cover screws (2 each for right and left). Insert the supplied M4 screws (gray, 4 screws each for right and left) into the bracket attachment holes and temporarily tighten them. Tighten the screws completely with a coin and lock the speakers. Close the panel cover and tighten the panel cover screws (2 screws each for right and left. Only use the supplied screws when installing the speakers. When you connect the cord to the right speaker, pull out the cord from under the monitor panel cover and lay it under the monitor to the right speaker. use the supplied speaker cord holders to tuck the cord. For details on how to attach the speaker cord holder, see "To install the speaker cord holders" on next page. Similarly, when you connect the cord to the left speaker, pull out the cord from under the monitor panel cover and lay it under the monitor to the left speaker. Tuck any excess cord inside the panel cover. To install the speaker cord holders As shown in the figure, insert the holders into the holes on the ventilation openings. Evenly space the holders and insert them under the monitor cover. If you use an optional mounting bracket, the bracket position and the holder positions should not overlap. Be careful not to short-circuit the speaker terminals according to the wire sticking out of the insulation. Correct `' connections of both speaker systems insures proper inphase operation. [. . . ] If you use an optional mounting bracket, the bracket position and the holder positions should not overlap. Be careful not to short-circuit the speaker terminals according to the wire sticking out of the insulation. Correct `' connections of both speaker systems insures proper inphase operation. If the speaker system is out-of-phase, the bass tones seem to be missing and the position of the sound sources become obscure. [. . . ]