User manual SONY ST-A6B new circuit operation

[. . . ] To disconnect the cord, pull it out by grasping the plug. AC power cord must be changed only at the qualified service shop. Place the unit in a location with adequate ventilation to prevent heat buildup and prolong the life of its components. â· Do not place the unit near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. [. . . ] Turn TUNING/SELECT until "GERMAN" appears and then press ENTER. While pressing down the numeric button 2, press U to turn on the tuner. Repeat the procedure above to select "POLAR" instead. In POLAR mode (Stereo Plus), the tuner receives FM broadcasts that are only within a frequency range of 65 MHz to 74 MHz. Repeat the procedure above to select "ENGLISH" instead. This section shows you how to receive preset stations. Make sure you've hooked up the tuner and preset stations. Each time you turn TUNING/SELECT, a preset station is received and the settings (preset code, frequency, and station name, etc. This tuner uses a menu entry system which allows you to operate various functions by following messages on the display. Use the following controls for menu operation. You can select the appearance of the display from one of the following four display modes. If the entered numbers are still flashing, the frequency is not used in your area. This tuner has various functions designed for better reception. First, try to receive stations with the standard settings. If the reception is not good, try altering the reception quality to obtain a clear signal. The tuner stores the FM mode, together with the frequency when you make a station preset either manually or automatically (see this page and page 11). Press FM MODE a few times to choose the reception mode, select either Auto stereo (no indication) or MONO. Stations will be received in monaural but with even less noise. This section shows you how to store up to 40 of your favorite FM or AM stations manually onto preset codes made up of characters (A, B, C, or D) and numbers (1-0), such as A7. You can store up to 10 stations on each of the 4 different letters. You can use these letters to classify stations according to music category or station band. "MEMORY" appears along with the lowest vacant code to indicate that the tuner is ready to store the station. [. . . ] When the station is tuned in, the station name will appear instead of the frequency. Turn TUNING/SELECT until "CHAR" appears and then press ENTER. turn TUNING/SELECT to select a character. When the character you want appears, press MEMORY to move the cursor into position for the next character. [. . . ]